Loading...
Starting at $10.95, AutoBuffy stocks 2 vehicle speed sensor connectors from Standard Ignition and Dorman for the Acura Tl. This connector links the speed sensor to the vehicle's wiring harness, transmitting wheel or transmission speed data to the ECU. A damaged or corroded connector breaks that signal, triggering speedometer errors, ABS faults, and erratic transmission shifts.
The main decision is whether you need the transmission-side connector, the wheel-speed (ABS) sensor connector, or a repair pigtail versus a full OEM-style plug-and-play assembly. Confirm the connector location — transmission output, rear differential, or wheel hub — before ordering, because terminal count and wire gauge differ by position.
| Option | Best for | What you get |
|---|---|---|
| OEM-style replacement connector | Owners who want a factory fit with no splicing | Exact plug geometry, correct terminal count, and pre-installed terminals ready to swap |
| Repair pigtail (pigtail assembly) | Connectors with damaged or melted wiring near the plug | 6–12 inches of pre-tinned wire attached to a new connector so you splice past the damaged section |
| Transmission output speed sensor connector | Vehicles with shift-quality or speedometer issues traced to the gearbox | Connector matched to the speed sensor mounted on the transmission housing or tail shaft |
| Wheel/ABS speed sensor connector | ABS, traction control, or stability control faults traced to a wheel hub sensor | Weatherproof connector sized for the smaller ABS sensor found at each wheel end |
Locate the speed sensor connector at the transmission, differential, or wheel hub, unplug it, and inspect the terminals before installing the new connector. For a pigtail repair, cut the harness cleanly past the damaged section, strip both ends, and use heat-shrink crimp connectors to secure each wire by color. After installation, apply a small amount of dielectric grease to the terminals, reconnect the plug until it clicks, and clear any stored codes before test driving.