Loading...
Trailing arm bushings for your Bmw 330Ci start at $7.95, and AutoBuffy stocks 6 options from URO, Delphi, and Mevotech Original Grade. These rubber or polyurethane sleeves isolate the trailing arm from the chassis, absorbing road impacts and keeping rear wheel alignment geometry stable. When they crack or collapse, you lose handling precision, accelerate tire wear, and introduce clunking noise over bumps.
The two main decisions are material — rubber versus polyurethane — and whether to buy individual bushings or a complete trailing arm assembly. Rubber is quieter and closer to OE feel; polyurethane is firmer, more durable, and better suited to performance or heavy-use applications. Some vehicles make bushing-only replacement difficult due to pressed-in designs, making a complete arm assembly the more practical choice.
| Option | Best for | What you get |
|---|---|---|
| OE-replacement rubber bushing | Daily drivers wanting factory ride quality and quiet operation | Matched durometer to OEM spec, bolt-in fit, standard service life |
| Polyurethane bushing (greaseable) | Performance driving, towing, or high-mileage vehicles needing longer service life | Firmer suspension feel, higher resistance to tearing and compression set, requires periodic greasing |
| Complete trailing arm assembly (with bushings pre-pressed) | Vehicles with seized or heavily corroded arms, or when labor cost of pressing bushings exceeds arm cost | Ready-to-install unit, eliminates need for press, saves labor time |
| Bushing kit (both sides) | Full rear suspension refresh or when one bushing is worn but the opposite side is similarly aged | Matched pair ensures even compliance and alignment on both sides, often a better value than single units |
Raise and support the vehicle, then remove the trailing arm by unbolting it from both the chassis and the wheel knuckle or axle. Drive or press the old bushing out of the arm bore and press the new bushing in squarely until fully seated. Reinstall the arm with the vehicle at ride height before final torquing of fasteners, then have a four-wheel alignment performed to confirm rear geometry is within specification.