Loading...
Starting at $71.95, AutoBuffy stocks 1 HVAC blower motor housing covers from URO. This cover encloses the blower motor assembly, keeping debris out and directing airflow efficiently through the cabin. When it cracks, warps, or breaks, air leaks past the housing, reducing heat and A/C output and allowing dirt and moisture to damage the motor itself.
The main decision is whether to buy an OE-equivalent replacement or an upgraded aftermarket cover, and whether you need the full housing assembly or just the cover panel. Fit is critical — a cover that does not seat flush against the blower cage will leak air and reduce system efficiency regardless of quality.
| Option | Best for | What you get |
|---|---|---|
| OE-Equivalent Replacement Cover | Owners who want a direct, no-modification fit | Same geometry and mounting points as the factory part; straightforward swap with no trimming or adapting |
| Full Blower Motor Housing Assembly | Cases where the cover and cage are both cracked or the motor is being replaced at the same time | Complete enclosure plus motor mount; eliminates the need to reuse any worn housing components |
| Heavy-Duty Aftermarket Cover | High-mileage vehicles or climates with extreme heat that cause repeated OE warping | Thicker or higher-heat-resistant plastic that resists cracking longer than standard OE material |
| Upper vs. Lower Housing Cover | Situations where only one section of a two-piece housing is damaged | Targeted replacement of just the broken half, saving cost when the other half is still intact and undamaged |
On most vehicles the blower motor housing is located under the passenger-side dash, accessible after removing one or two trim panels. The cover is typically held by a series of screws and plastic clips; removing them allows the cover to be pulled free without disturbing the rest of the HVAC system. Seat the new cover firmly against the housing flange and verify all clips and screws are fully engaged before reinstalling trim panels to ensure an airtight seal.