Loading...

Bmw 740Li Xdrive Air Suspension Solenoid Valves

Bmw 740Li Xdrive Air suspension solenoid valves

Starting at $50.95, AutoBuffy stocks 8 air suspension solenoid valves from Arnott, VEMO, and FCS for the Bmw 740Li Xdrive. This valve controls airflow into and out of each air spring, maintaining ride height and cushion. When it fails, the affected corner sags, the compressor overworks, and the system triggers warning lights — often leading to a rough, uneven ride or compressor burnout if ignored.

Signs your Bmw 740Li Xdrive needs a new air suspension solenoid valve

  • One corner of the vehicle sits noticeably lower than the others, especially after sitting overnight
  • The air suspension warning light or 'Check Suspension' message appears on the dash
  • The compressor runs continuously or cycles on and off far more frequently than normal
  • You hear a hissing or clicking sound near a wheel well when the system tries to inflate or adjust
  • Ride height does not correct itself after loading the vehicle or driving over a dip
  • The vehicle fails to raise or lower on demand when using the manual height adjustment controls

Which air suspension solenoid valve should you buy for your Bmw 740Li Xdrive?

The main decision is whether to buy an OE-equivalent replacement, an upgraded aftermarket unit, or a position-specific valve if your Bmw 740Li Xdrive uses separate front and rear solenoids. Fit is critical — solenoids are not universally interchangeable across positions or Bmw platforms, so confirm the valve location (front left, front right, rear, or integrated manifold block) before ordering.

OE-Equivalent Replacement
Best for
Owners who want factory-matched performance and plug-and-play installation
What you get
Exact connector, flow rate, and mounting dimensions as the original; no adaptation needed
Aftermarket Direct-Fit (Single Valve)
Best for
Targeted repair of one failed corner without replacing the full system
What you get
Position-specific valve at a lower cost than the full manifold; same seals and solenoid coil rating
Solenoid Valve Manifold / Block
Best for
Vehicles where multiple valves share a single housing (common on rear-air systems)
What you get
Replaces all valves at once, eliminating multiple leak points; more labor-efficient than individual swaps
Upgraded / Heavy-Duty Solenoid
Best for
High-mileage vehicles, frequent towing, or those with a history of repeated solenoid failures
What you get
Reinforced coil windings and improved O-ring seals rated for higher duty cycles and temperature extremes

Air suspension solenoid valves brands we stock for your Bmw 740Li Xdrive

Arnott
2 options · from $214.95
VEMO
1 option · from $226.95
FCS
1 option · from $85.95
URO
1 option · from $150.95
Suncore
1 option · from $54.95
Unity
1 option · from $50.95
Westar
1 option · from $105.95

Replacing an air suspension solenoid valve on a Bmw 740Li Xdrive

Moderate⏱ 1–2 hoursSocket set and ratchetFlathead and Phillips screwdriversTrim panel removal tools (for access panels or wheel liners)Compatible OBD scan tool with suspension module accessNeedle-nose pliers (for wire harness clips)

Before starting, use a scan tool to vent and depressurize the air suspension system — working on a pressurized system can cause components to eject forcefully. Remove the wheel liner or access panel to reach the valve, disconnect the electrical connector and air line, and swap in the new solenoid with fresh O-rings lightly lubricated with clean silicone grease. After installation, re-pressurize the system, check for leaks at the new valve connections, and clear any stored fault codes before returning the vehicle to service.

Frequently asked questions

How much does it cost to replace air suspension solenoid valves on a Bmw 740Li Xdrive?
Parts start at $50.95 at AutoBuffy. A single solenoid valve is typically the more affordable fix; a full manifold block costs more. Add shop labor of one to two hours if you're not doing it yourself. Catching a failed solenoid early prevents compressor damage, which costs significantly more to replace.
Can I drive my Bmw 740Li Xdrive with a bad air suspension solenoid valve?
You can drive short distances, but it is not recommended. A failed solenoid causes one corner to sag, creating uneven handling and tire wear. More critically, the compressor will run excessively trying to compensate, leading to compressor burnout — a much more expensive repair than replacing the solenoid alone.
How do I know which solenoid valve has failed on my Bmw 740Li Xdrive?
The most reliable method is reading the suspension control module fault codes with a scan tool that supports chassis or suspension systems — basic OBD-II readers often miss these codes. The corner that sags overnight also points directly to the faulty valve or air spring. A soapy-water leak test around each valve while the system is pressurized can confirm the source.
Is a leaking air suspension solenoid different from a leaking air spring on a Bmw 740Li Xdrive?
Yes, and distinguishing them matters before you order parts. A solenoid leak is typically at the valve seat or O-ring and produces a slow bleed when the system is at rest. An air spring leak usually comes from a cracked bladder or failed crimp. Fault codes and a physical leak-down test help separate the two causes.
Do I need to replace all solenoid valves at once on my Bmw 740Li Xdrive?
Not always, but it is worth considering. If the Bmw 740Li Xdrive has high mileage and one solenoid has failed, the others are likely near the end of their service life as well. Replacing all valves — or the full manifold if your system uses one — during the same service call reduces labor costs and the chance of a repeat repair soon after.
Will replacing the solenoid valve reset the air suspension warning light on my Bmw 740Li Xdrive?
Replacing the faulty valve removes the root cause, but the warning light typically requires a manual reset using a compatible scan tool after the repair. On some Bmw platforms the light clears itself after several successful ride-height cycles, but using a scanner confirms no additional fault codes remain active before assuming the system is fully resolved.

Shop air suspension solenoid valves by year for the Bmw 740Li Xdrive

201520142013

More parts for your Bmw 740Li Xdrive

Brake Rotor SetOxygen SensorTransmission MountElectrical Pin ConnectorAccessory Drive Belt Tensioner AssemblyTurbochargerAmbient Air Temperature SensorBrake Hydraulic Hose

Air suspension solenoid valves for other Bmw models

Bmw 745e xDriveBmw M760Li xDriveBmw Alpina B7Bmw 740Ld xDriveBmw 745iBmw 535i