Loading...
Starting at $99.95, AutoBuffy stocks 6 evaporative emissions system leak detection pumps from Standard Ignition, Bosch, and Dorman. The leak detection pump pressurizes the EVAP system so the ECM can check for fuel vapor leaks. When it fails, your Bmw 750I can't complete EVAP readiness tests, triggering a check engine light and causing smog inspection failures.
Leak detection pumps vary primarily by whether you buy the pump motor alone, the full assembled unit with integrated solenoids and filter, or an OE-equivalent part versus an aftermarket value option. For most owners, the complete assembly is the better choice since the solenoid, filter, and motor typically fail together and individual sub-components are rarely sold separately.
| Option | Best for | What you get |
|---|---|---|
| OE-Equivalent Complete Assembly | Owners who want a direct, no-hassle swap and long-term reliability | Full pump with integrated vent solenoid, pressure switch, and filter matched to factory specs |
| Aftermarket Value Complete Assembly | Budget-conscious owners with a high-mileage Bmw 750I not needing OE-level longevity | Full replacement unit at a lower price point; may use less robust internal materials |
| Pump Motor Only (if available for Bmw 750I) | DIYers who have confirmed via bench testing that only the motor has failed | Bare motor without solenoid or filter; requires reuse of existing housing and sub-components |
| Remanufactured Unit | Owners who prefer a tested, rebuilt option over a new aftermarket part | Rebuilt to OE tolerances, often with a core charge; good middle ground between cost and quality |
Raise and support the Bmw 750I safely if the pump is mounted beneath the chassis, disconnect the electrical connector and vapor lines from the old pump, and unbolt or unclip the pump from its bracket. Install the new unit in reverse order, ensuring vapor line connections are fully seated and the electrical connector locks in place. Clear stored codes with an OBD-II scanner and complete a cold-start drive cycle to confirm the EVAP monitor runs to completion.