Loading...

Bmw 750Il Stability Control Pressure Sensors

Bmw 750Il Stability control pressure sensors

Starting at $175.95, AutoBuffy stocks 1 stability control pressure sensors from URO for the Bmw 750Il. This sensor monitors hydraulic pressure in the brake circuit, feeding real-time data to the ESC module so it can apply selective braking during a skid. A failed sensor triggers the ESC warning light and disables active stability intervention, leaving you without electronic skid protection.

Signs your Bmw 750Il needs a new stability control pressure sensor

  • ESC, StabiliTrak, VSC, or DSC warning light illuminates on the dashboard
  • ABS warning light comes on at the same time as the stability control light
  • Brake pedal feels spongy or inconsistent even though pads and fluid are fine
  • Stability control system is permanently disabled and cannot be re-enabled with the button
  • Stored fault codes pointing to brake pressure sensor circuit — typically C-series chassis codes
  • Traction control intervenes erratically or not at all during low-grip acceleration

Which stability control pressure sensor should you buy for your Bmw 750Il?

The main decision is whether to buy an OE-equivalent direct-fit sensor or a universal unit that requires splicing. For most owners, a direct-fit replacement is faster to install and less likely to cause communication errors with the ESC module. Also confirm whether your Bmw 750Il uses a single master-cylinder-mounted sensor or dual sensors placed at individual calipers, as these are not interchangeable.

OE-Equivalent Direct-Fit
Best for
Daily drivers who want a plug-and-play swap with no coding
What you get
Exact connector, pressure range, and signal output matched to the factory ESC module
OEM Supplier (Tier-1 Brand)
Best for
Owners who want factory-level quality without dealer pricing
What you get
Parts made by the same supplier that built the original, sold under an aftermarket label
Economy / Value-Line
Best for
High-mileage vehicles where budget matters more than longevity
What you get
Functional replacement at lower cost; may have shorter warranty and wider tolerance band
Universal / Adjustable-Range Sensor
Best for
Custom builds or vehicles where a direct fit is unavailable
What you get
Broad pressure range with bare-wire leads; requires splicing and may need ECU recalibration

Stability control pressure sensors brands we stock for your Bmw 750Il

URO
1 option · from $175.95

Replacing the stability control pressure sensor on a Bmw 750Il

Moderate⏱ 45 minutes – 1.5 hoursOBD-II scan tool (to read and clear fault codes)Flare-nut or sensor socket sized to the fittingDrain pan and brake fluidElectrical contact cleaner and dielectric greaseBrake bleeder kit or a helper for manual bleeding

Disconnect the electrical connector and unthread the old sensor, keeping a rag handy to catch brake fluid. Thread the new sensor in by hand first to avoid cross-threading, then snug it firmly — consult the new sensor's documentation for the recommended tightening range. Bleed the affected circuit if fluid was lost, refill the reservoir, clear any stored fault codes with a scan tool, and verify the ESC warning light extinguishes after a short test drive.

Frequently asked questions

How much does it cost to replace stability control pressure sensors on a Bmw 750Il?
Parts start at $175.95 at AutoBuffy. A shop will typically add one to two hours of labor on top of the part cost. Total out-of-pocket at a repair facility is usually higher than a DIY swap, where you pay only for the sensor and any needed brake fluid to top off after the job.
Is it safe to drive my Bmw 750Il with a faulty stability control pressure sensor?
You can drive short distances carefully, but it is not recommended for extended use. A failed sensor disables the ESC system entirely, meaning the vehicle will not apply corrective braking during oversteer or understeer. Normal braking is usually unaffected, but you lose an important safety layer in emergency maneuvers or slippery conditions.
Will the ESC warning light clear itself after I replace the sensor on my Bmw 750Il?
In many cases the light clears after a short drive once the module confirms valid pressure readings. However, some Bmw 750Il models require a scan tool to erase the stored fault code before the light goes out. If the light remains on after replacement and a road test, connect an OBD-II scanner and clear the code manually.
Do I need to bleed the brakes after replacing the stability control pressure sensor on my Bmw 750Il?
It depends on sensor location. A sensor threaded into the ABS modulator or master cylinder will expose the hydraulic circuit when removed, requiring bleeding of that circuit afterward. A sensor mounted externally on a line without being opened may not introduce air. Check whether fluid drains when you remove the old sensor before deciding.
How do I know if the pressure sensor or the ESC module itself is bad on my Bmw 750Il?
Pull the fault codes first. A code pointing to sensor signal voltage, open circuit, or out-of-range pressure strongly suggests the sensor. A code flagging internal module faults or multiple unrelated ESC inputs failing simultaneously points toward the module. Swapping in a known-good sensor and re-testing is the most reliable way to confirm before purchasing a more expensive module.
How long does a stability control pressure sensor last on a Bmw 750Il?
Most sensors last many years under normal conditions, but they are vulnerable to moisture intrusion, road salt corrosion at the connector, and gradual diaphragm fatigue from repeated pressure cycles. Vehicles in rust-belt climates or with a history of brake fluid neglect tend to see earlier failure. Replacing aged brake fluid on schedule helps extend sensor life.

Shop stability control pressure sensors by year for the Bmw 750Il

2001200019991998

More parts for your Bmw 750Il

CV Joint BootTrailing ArmAir Charge Temperature Sensor ConnectorSubframe BushingControl Arm Repair KitSpark Plug Wire SetFuel Tank Breather ValveEngine Crankshaft Position Sensor

Stability control pressure sensors for other Bmw models

Bmw 760iBmw 323iBmw 645CiBmw 750LiBmw 328CiBmw 745Li