Loading...

Chrysler C33 Automatic Transmission Oil Cooler End Fittings

Chrysler C33 Automatic transmission oil cooler end fittings

Starting at low prices, AutoBuffy stocks multiple automatic transmission oil cooler end fittings from top OE-quality brands. This fitting is the threaded or push-connect coupling that joins the transmission cooler line to the cooler itself. When it fails, transmission fluid leaks at the cooler connection, starving the transmission of lubrication and cooling — leading to overheating and premature failure.

Signs your Chrysler C33 needs a new automatic transmission oil cooler end fitting

  • Reddish or brownish fluid puddle forming directly beneath the front of the vehicle near the radiator or auxiliary cooler
  • Visible wet seepage or crust of dried fluid around the fitting where the cooler line meets the cooler tank
  • Transmission fluid level drops repeatedly even after topping off, with no other obvious source of loss
  • Transmission slipping, delayed engagement, or harsh shifts caused by low fluid pressure from chronic seepage
  • Burning smell from the engine bay as leaked fluid contacts hot exhaust or radiator surfaces
  • Transmission temperature warning light or gauge reading higher than normal due to reduced coolant flow through the cooler

Which automatic transmission oil cooler end fitting should you buy for your Chrysler C33?

The main decisions are fitting style (threaded vs. quick-connect/push-in), material (OE-spec plastic composite vs. all-metal), and whether you need an inlet or outlet position. Matching the correct style and thread size to your existing cooler and line is critical — a mismatched fitting will not seal properly and will leak immediately.

OE-Replacement Threaded Fitting
Best for
Restoring factory function with a direct swap
What you get
Matches original thread pitch and diameter; typically nylon-reinforced composite or steel; straightforward install
OE-Replacement Quick-Connect Fitting
Best for
Vehicles with push-in style cooler lines at the factory
What you get
Snap-in design that mates to existing line retaining clips; no threading required; must match line OD exactly
All-Metal Upgrade Fitting
Best for
High-tow, severe-duty, or high-mileage applications
What you get
Brass or aluminum construction; more resistant to heat cycling and vibration cracking than plastic composite OE units
Repair Kit (Fitting + O-Ring + Clip)
Best for
Addressing the full leak point in one purchase
What you get
Includes the fitting, replacement sealing O-ring, and retaining clip; reduces the chance of a repeat leak from aged ancillary seals

Replacing an automatic transmission oil cooler end fitting on a Chrysler C33

Easy⏱ 30–60 minutesDrain pan or absorbent shop padsLine disconnect tool set (for quick-connect fittings)Open-end or flare-nut wrenches (for threaded fittings)Needle-nose pliers (for retaining clips)Transmission fluid and funnel for topping off after repair

Place a drain pan beneath the cooler before loosening anything, as residual fluid will spill when the line is disconnected. Remove the retaining clip or unthread the fitting, swap in the new fitting with a fresh O-ring lightly coated in clean transmission fluid, and reseat or thread it to snug resistance — do not overtighten. Top off the transmission fluid to the correct level, run the engine through the gear positions, and inspect the fitting for any seepage before returning the vehicle to service.

Frequently asked questions

How much does it cost to replace automatic transmission oil cooler end fittings on a Chrysler C33?
Parts start at low prices for a Chrysler C33 end fitting at AutoBuffy. A shop will typically add one to two hours of labor. Because the fitting itself is inexpensive, the majority of the total repair cost is usually labor, fluid replacement, and a transmission fluid flush if contamination or low fluid caused secondary damage.
Can I drive my Chrysler C33 with a leaking transmission cooler end fitting?
You should not drive with a leaking fitting beyond what is necessary to reach a shop. Even a slow seep will progressively lower fluid level, causing the transmission to run hot and under-lubricated. Continued driving risks burnt fluid, solenoid damage, and internal clutch wear that turns a minor repair into a major transmission rebuild.
Are automatic transmission oil cooler end fittings vehicle-specific?
Yes. Fittings vary by thread size, fitting style (threaded vs. quick-connect), line outer diameter, and whether they serve the inlet or outlet port. Using the correct all model years Chrysler C33 fitment ensures proper sealing. Always confirm the position — inlet or outlet — because some cooler designs use different fittings at each end.
Should I replace the O-ring when I replace the end fitting on a Chrysler C33?
Always replace the O-ring at the same time. The O-ring is the primary sealing element, and the heat cycling that degraded the old fitting has almost certainly hardened or flattened the existing O-ring as well. Installing a new fitting against a worn O-ring is a common cause of a repeat leak within a short period.
How do I know if my Chrysler C33 uses a threaded or quick-connect cooler end fitting?
Inspect the existing fitting before ordering. A threaded fitting will show visible threads on the cooler port and require a wrench to remove. A quick-connect fitting will have a visible retaining clip or tab and release by depressing a collar or tab on the line. Your Chrysler C33 parts listing will also specify the style when you enter your exact year and trim.
Will a transmission fluid flush be necessary after replacing the end fitting on a Chrysler C33?
A flush is not always mandatory, but it is strongly recommended if the fitting leaked long enough to cause fluid loss or overheating. Overheated transmission fluid breaks down and turns dark or smells burnt. Fresh fluid after a repair protects seals and friction surfaces and gives you a clear baseline for monitoring the new fitting's seal.

More parts for your Chrysler C33

Auxiliary Engine Cooling Fan AssemblyShock Absorber SetEngine Oil Cooler Mounting KitDistributor RotorAutomatic Transmission Oil CoolerAutomatic Transmission Oil Cooler HoseTie Rod EndAuxiliary Engine Cooling Fan Relay

Automatic transmission oil cooler end fittings for other Chrysler models

Chrysler Executive LimousineChrysler ConcordeChrysler St RegisChrysler CordobaChrysler Chrysler R/TChrysler C34