Loading...
Starting at $32.95, AutoBuffy stocks 6 alignment caster/camber bushings from Mevotech Supreme. These rubber or polyurethane bushings mount inside the control arm or subframe to set the precise angle at which your wheels sit and sweep. When they crack, collapse, or shift, your Dodge W100 loses its alignment geometry — causing uneven tire wear, pull, and handling instability that realignment alone cannot fix.
The main decisions are material (OE-rubber vs. polyurethane), whether you need an eccentric/adjustable bushing to dial in corrected geometry, and whether you're replacing a single worn piece or doing both sides as a set. Confirm the specific control arm location — front lower, front upper, or rear — because bushing geometry differs by position and a mismatch will throw off your alignment targets.
| Option | Best for | What you get |
|---|---|---|
| OE-Replacement Rubber Bushing | Daily drivers wanting stock ride quality and easy installation | Factory-matched durometer, absorbs NVH well, straightforward press-in fit with standard alignment specs |
| Polyurethane Bushing | Performance or high-mileage vehicles needing longer service life | Firmer feel, resists oil and ozone degradation, reduces deflection for more consistent alignment — some added harshness on rough roads |
| Eccentric / Offset Adjustable Bushing | Vehicles with worn subframes, lifted/lowered suspensions, or out-of-range camber/caster | Rotating offset sleeve lets a technician dial in alignment angles beyond the factory adjustment range |
| Bushing Kit (Axle Set) | Complete refresh or when one side shows wear that suggests the other is close behind | Both left and right bushings matched in material and spec, often at a lower per-unit cost than buying singles |
Caster/camber bushings are pressed into the control arm housing or subframe bracket, so removal requires a proper bushing press or a hydraulic press with the correct cup adapters — driving them out with a hammer risks damaging the housing bore. The control arm must be unloaded from suspension weight before loosening the pivot hardware, and all fasteners should be torqued with the suspension at ride height to prevent bushing wind-up. Because this job directly affects alignment geometry, a professional four-wheel alignment is mandatory as the final step.