Loading...
Starting at $142.95, AutoBuffy stocks 2 fuel pump hanger assemblies from Delphi. The hanger assembly mounts the fuel pump and sending unit inside the fuel tank, holding them at the correct depth while routing fuel and return lines to the engine. When it fails, the pump loses its position or the sending unit loses contact, causing stalling, no-starts, or a permanently incorrect fuel gauge.
The most important decision is whether to buy a hanger-only unit or a complete module that includes a new pump, sending unit, and strainer. If your pump tests good but the float arm or flange is damaged, a hanger assembly alone saves money. If the pump is marginal or unknown, a complete module replaces every failure point in one job.
| Option | Best for | What you get |
|---|---|---|
| Hanger assembly only (no pump) | Good pump, broken float arm or cracked flange | Mounting bracket, float arm, sending unit, O-ring seal — no pump or strainer |
| Complete fuel pump module | High-mileage vehicles or unknown pump history | Hanger, pump, sending unit, strainer, and all seals as a ready-to-install unit |
| OE-equivalent replacement | Restoring stock fuel pressure and gauge accuracy | Direct-fit dimensions, matched float travel, same connector as factory |
| Performance / upgraded module | Modified engines with higher fuel demand | Higher flow pump on the OE hanger frame, compatible with stock fuel lines and connectors |
Relieve fuel system pressure, disconnect the battery, and drain or lower fuel level before opening the tank. Remove the lock ring securing the hanger flange, lift the assembly straight up slowly to avoid bending the float arm, and transfer any reusable components to the new hanger. Install with a fresh O-ring, torque the lock ring evenly to the manufacturer's specification range, reconnect all lines and electrical connectors, then cycle the ignition several times before cranking to reprime the system.