Loading...
Starting at $82.95, AutoBuffy stocks 1 sunroof control module connectors from Standard Ignition to fit your Gmc K1500. This connector links the sunroof control module to the vehicle's wiring harness, carrying the power, ground, and signal circuits that operate the panel. A damaged or corroded connector causes the sunroof to stop responding entirely or behave erratically, making prompt replacement essential.
The most important buying decision is whether to choose an OEM-specification pigtail connector or an aftermarket universal-fit unit, and whether you need the full connector assembly with pre-terminated wires or just the bare housing and terminals. Matching the correct pin count and connector body style to your Gmc K1500's existing harness is critical — an incorrect fit means the module will not seat properly and circuits will not carry current reliably.
| Option | Best for | What you get |
|---|---|---|
| OEM-spec pigtail assembly | Owners who want a direct plug-in repair with no splicing | Connector housing, correct-gauge pre-terminated lead wires, and factory-matching terminal pins ready to solder or butt-connect into the existing harness |
| Aftermarket direct-fit connector | Budget-conscious repairs where OEM sourcing is slow or expensive | Connector body and terminals designed to match the original cavity count and locking tab style, typically at a lower price point |
| Bare housing with loose terminals | Technicians repairing only damaged pins rather than replacing the full connector | Just the plastic housing and a set of individually replaceable terminals, allowing targeted repair without cutting into the harness |
| Weatherproof sealed connector kit | Vehicles in high-humidity or sunroof-leak-prone environments | Connector with integral rubber seals on each terminal cavity, reducing the chance of future corrosion that caused the original failure |
Begin by disconnecting the battery negative terminal and removing any headliner or trim panels needed to access the sunroof module and its connector — location varies by Gmc K1500 but is typically near the front or rear of the sunroof opening. Release the locking tab on the old connector, transfer or splice in the new pigtail connector using solder-and-heat-shrink or quality butt connectors, then reinstall trim and reconnect the battery. Finish by performing the sunroof initialization reset procedure described in your Gmc K1500 owner's manual to re-establish panel travel limits.