Loading...

Infiniti G20 CV Joint Boots

Infiniti G20 Cv joint boots

CV joint boots for your Infiniti G20 start at low prices, with multiple options in stock from top OE-quality brands. The boot is a rubber bellows that keeps grease packed around the CV joint while sealing out dirt and moisture. When it cracks or tears, contamination destroys the joint quickly — catching a failed boot early can save you from replacing the entire CV axle.

Signs your Infiniti G20 needs a new CV joint boot

  • Grease splattered on the inside of the wheel, rim face, or along the inside of the fender well — the most obvious sign of a torn boot
  • A clicking or popping noise when turning at low speed, especially in tight parking-lot turns, indicating grease loss has already begun damaging the joint
  • A visible crack, split, or hole in the rubber bellows when you inspect around the axle shaft near the wheel or near the transmission
  • Grease flung onto the brake rotor or caliper, which can contaminate brake pads and reduce stopping power
  • A clunking sensation felt through the floorboard or steering wheel during acceleration from a stop, signaling joint wear from prolonged boot failure
  • Vibration at highway speed that worsens under load, which can develop once a compromised CV joint begins to wear unevenly

Which CV joint boot should you buy for your Infiniti G20?

The main decision is whether to use a traditional clamp-style boot that requires axle removal or a split (slip-on) boot that can be installed without pulling the axle. Beyond that, material quality and whether the kit includes clamps and fresh grease determine how long the repair lasts. Match the boot to the correct axle position — inner and outer boots are different sizes.

OE-style rubber boot kit (outer)
Best for
Drivers who want factory fit and are already removing the axle
What you get
Molded rubber boot sized for the outer CV joint, clamps, and grease packet — direct replacement for the original
OE-style rubber boot kit (inner)
Best for
Replacing the larger tripod or ball-type inner joint boot during the same job
What you get
Wider-diameter boot matched to the inner joint geometry, with clamps and grease — inner and outer kits are not interchangeable
Split/wrap-around boot (no-pull)
Best for
DIYers who want to avoid full axle removal on a joint that is still in good condition
What you get
Pre-slit thermoplastic or rubber boot that wraps around the shaft and bonds or clamps shut — saves removal time but requires careful sealing
Heavy-duty CV boot kit (polyurethane or premium rubber)
Best for
High-mileage vehicles, trucks, or AWD/4WD applications with higher joint stress
What you get
Thicker-walled boot with upgraded clamps rated for greater heat and flex cycles — longer service life than standard rubber in demanding conditions

Replacing a CV joint boot on a Infiniti G20

Moderate⏱ 1.5–3 hoursFloor jack and jack standsSocket set and breaker bar (for axle nut)CV boot clamp pliers or a flat clamp toolSnap ring pliersPlastic scraper and shop rags for cleaning old grease

The job involves removing the wheel, unbolting the axle from the hub or disconnecting it from the transmission depending on which end you are servicing, sliding off the old boot, thoroughly cleaning old grease from the joint, packing in the new grease, and securing the new boot with both clamps. Clamps must be seated firmly to prevent grease escape and water entry — loose clamps are the most common cause of premature boot failure after a DIY install. A split boot eliminates most of the disassembly but demands careful seam preparation and bonding for a lasting seal.

Frequently asked questions

How much does it cost to replace CV joint boots on a Infiniti G20?
Boot kits for a Infiniti G20 start at low prices for a single axle position. DIY part cost is low compared to labor — shop rates for the full job, including axle removal and regreasing, typically push total costs higher. Replacing both boots on one axle at the same time is efficient if one is already cracked.
Can I drive my Infiniti G20 with a torn CV joint boot?
You can drive short distances, but it accelerates damage significantly. Once the boot tears, grease escapes and grit enters the joint. Within a few hundred miles of normal driving the CV joint itself can wear to the point of failure, turning a low-cost boot replacement into a full axle replacement.
Do I need to replace the entire CV axle or just the boot on my Infiniti G20?
If the boot is freshly torn and the joint still moves smoothly and quietly with no clicking, replacing just the boot and repacking with fresh grease is a sound repair. If the joint already clicks, pops, or feels rough when rotated by hand, the damage is done and replacing the full axle shaft is the better value.
How long do CV joint boots last on a Infiniti G20?
Boot lifespan varies widely based on material quality, road conditions, and exposure to road salt or debris. Generally expect anywhere from 60,000 to 100,000 miles under normal conditions. Vehicles driven in harsh climates or on rough roads may see boots crack or harden much sooner. Inspecting them during routine brake or tire service catches failures early.
Is a split CV boot as good as a standard boot on a Infiniti G20?
A properly installed split boot is an acceptable repair when the joint is undamaged and clean, but the bonded seam is a potential weak point. Standard clamp-style boots installed with the axle removed create a better long-term seal. Split boots are a practical middle ground for situations where axle removal is difficult or labor cost is a concern.
What is included in a CV boot kit for a Infiniti G20?
Most kits include the boot itself, two clamps (a small clamp for the shaft end and a large clamp for the joint end), and a grease packet pre-measured for that joint type. Some kits also include snap rings or retaining clips. Verify the kit matches your axle position — inner and outer joints require different boots and grease quantities.

More parts for your Infiniti G20

Exhaust Pipe Flange GasketClutch Slave CylinderBrake RotorFuel Injector Seal KitA/C CompressorHVAC RelayComplete StrutAir Strut Set

Cv joint boots for other Infiniti models

Infiniti Q50Infiniti M35Infiniti FX35Infiniti QX56Infiniti G37Infiniti M56