Loading...
Hood dampers for your International 9100 Sba start at $73.95, and AutoBuffy stocks 1 options from Monroe. A hood damper is a gas-charged strut that holds the hood open hands-free, replacing a traditional prop rod. When it fails, the hood drops unexpectedly, creating a serious safety hazard and making routine engine bay access awkward and dangerous.
The main decisions are gas pressure rating, build quality, and whether you need a single strut or a matched pair. Most International 9100 Sba hoods use one or two dampers depending on the design, and replacing both at the same time is strongly recommended if one has failed — they wear at the same rate. OE-equivalent units restore factory hold force; heavy-duty options add extra lift force for heavier aftermarket hoods.
| Option | Best for | What you get |
|---|---|---|
| OE-Equivalent Replacement | Restoring stock function on a daily driver | Matched factory lift force, direct bolt-on fit, standard lifespan |
| Heavy-Duty / High-Pressure | Vehicles with heavier aftermarket hoods or frequent hood access | Higher gas charge holds hood more firmly, slower pressure loss over time |
| Pair / Kit (both sides) | Any vehicle using two hood struts | Matched lift force on both sides, balanced hood operation, better value than single |
| Economy / Value Grade | Budget repairs or low-mileage secondary vehicles | Functional replacement at lower cost, shorter expected service life |
Safely prop the hood open with a rod or have a helper hold it, then use a pry tool or wrench to release the old damper from its ball-stud mounts at the top and bottom — most International 9100 Sba applications use a snap-clip fitting that pops off with light leverage. Press the new damper firmly onto both ball studs until it clicks into place, then lower and re-raise the hood to confirm it holds position. No special calibration is required; the strut is pre-charged at the correct pressure for the International 9100 Sba from the factory.