Loading...

International S1824 Steering Drag Links

International S1824 Steering drag links

Steering drag links for your International S1824 start at $113.95, with 8 options in stock from Monroe, Delphi, and Dorman. The drag link is the long rod connecting the steering gear or pitman arm to the wheel-side steering knuckle or tie rod, transferring your steering input to the front wheels. A worn drag link causes vague, wandering steering that makes the vehicle unsafe to drive.

Signs your International S1824 needs a new steering drag link

  • Steering wheel wanders or drifts to one side on a straight, flat road without wind or crown
  • Loose, vague feeling in the steering wheel — excessive free play before the wheels respond
  • Clunking or knocking noise from the front end when turning or hitting bumps
  • Uneven or accelerated tire wear on the front axle, especially inner or outer edges
  • Vehicle pulls noticeably to one side that wheel alignment adjustment cannot fully correct
  • Visible grease loss, a torn boot, or detectable up-and-down slop at the drag link ball joints when inspected by hand

Which steering drag link should you buy for your International S1824?

The main decisions are OE-replacement vs. heavy-duty construction, and whether the drag link includes pre-installed end joints or sells as a bare tube. For lifted International S1824 applications, adjustable or long-travel drag links are a separate category altogether. Match the end-joint style (threaded, press-in, or greaseable) to your existing steering setup.

OE-Replacement (standard length)
Best for
Daily drivers staying at stock ride height
What you get
Factory dimensions, direct bolt-on fit, integrated or replaceable OE-style end joints
Heavy-Duty / Forged Steel
Best for
Trucks, SUVs, and work vehicles seeing rough roads or towing loads
What you get
Thicker tube wall, higher-rated ball joints, greaseable Zerk fittings for longer service life
Adjustable / Offset (lifted applications)
Best for
International S1824 with a suspension lift of 2 inches or more
What you get
Threaded or sleeve-style adjustment corrects geometry changes from lift; prevents bump-steer
Complete Drag Link Kit
Best for
Owners replacing worn hardware comprehensively
What you get
Drag link plus matching tie rod ends and/or sleeve, reducing return trips and ensuring joint compatibility

Steering drag links brands we stock for your International S1824

Monroe
6 options · from $113.95
Delphi
1 option · from $213.95
Dorman
1 option · from $171.95

Replacing the steering drag link on a International S1824

Moderate⏱ 1–2 hoursFloor jack and jack stands or a liftPickle fork or ball joint separatorCombination wrenches and/or sockets (standard and metric)Torque wrenchCotter pin remover and new cotter pins

Raise and support the front of the International S1824 safely, then remove the cotter pins and castle nuts at each drag link end joint before pressing the tapered studs free with a pickle fork or separator tool. Thread the new drag link to the same approximate depth as the old one before tightening, and install new cotter pins after torquing the nuts to the manufacturer's specification in your service manual. Schedule a four-wheel alignment immediately after the repair.

Frequently asked questions

How much does it cost to replace steering drag links on a International S1824?
Parts alone start at $113.95 for a International S1824 drag link. A shop will typically add one to two hours of labor on top of parts cost. Budget additional for a front-end wheel alignment afterward, which is required any time steering linkage components are replaced to prevent tire wear and pulling.
Is it safe to drive a International S1824 with a worn drag link?
No. A worn drag link with play in its ball joints means steering inputs are not fully or predictably transmitted to the front wheels. At highway speeds this creates a serious loss-of-control risk. If you detect clunking, wandering, or visible slop at the drag link, limit driving and replace the part promptly.
How long does a steering drag link last on a International S1824?
On a stock International S1824 used primarily on paved roads, a drag link commonly lasts many years and tens of thousands of miles. Off-road use, lifted suspensions, neglected grease fittings, and exposure to road salt significantly shorten service life. Inspect the boots and check for play at every tire rotation.
Do I need an alignment after replacing the drag link on my International S1824?
Yes, always. The drag link affects where the front wheels point. Even if you mark the old rod's thread depth before removal, there is enough variation in installation to shift toe alignment outside specification. Skipping alignment after the repair will cause rapid, uneven front tire wear and continued pulling.
Can I replace just the drag link end joints on my International S1824 instead of the whole assembly?
Often yes, if the center tube is straight and undamaged. Many drag links use threaded ends that can be replaced individually. However, if the tube is bent, corroded, or if end joints are not available separately for your International S1824, replacing the complete assembly is more cost-effective and restores full structural integrity.
What is the difference between a drag link and a tie rod on a International S1824?
On a International S1824 with a recirculating-ball or worm-gear steering box, the drag link carries steering motion from the pitman arm across to one knuckle or to the tie rod. The tie rod then links both front wheels together. On rack-and-pinion setups, a drag link is typically not used — inner and outer tie rods perform both functions.

Shop steering drag links by year for the International S1824

198519841983198219811980

More parts for your International S1824

Brake Pad SetDrum Brake ShoeDrum Brake Hardware KitBrake Master CylinderAlternatorDrive Shaft Center Support BearingStarter Brush SetStarter Brush Holder Assembly

Steering drag links for other International models

International F2674International F2276 SInternational 1724International 9400i SBAInternational S1723International S1853