Loading...

Jaguar F Type Engine Coolant Thermostat / Water Inlet Assemblys

Jaguar F Type Engine coolant thermostat / water inlet assemblys

Starting at low prices, AutoBuffy stocks multiple engine coolant thermostats and water inlet assemblies from top OE-quality brands. The thermostat regulates coolant flow between the engine and radiator, holding the engine at its optimal operating temperature. When it sticks open or closed, you risk overheating, poor fuel economy, heater failure, and potential engine damage.

Signs your Jaguar F Type needs a new engine coolant thermostat or water inlet assembly

  • Temperature gauge climbs into the red or the engine overheats shortly after startup
  • Temperature gauge reads lower than normal or the engine never reaches full operating temperature
  • Cabin heater blows lukewarm or cold air even after the engine has warmed up
  • Coolant leaking from the thermostat housing or water inlet where it meets the engine block or head
  • Check engine light on with a coolant temperature sensor or thermostat-related code (e.g., P0128 or P0125)
  • Noticeable drop in fuel economy because the ECU runs a richer fuel mixture when it thinks the engine is cold

Which engine coolant thermostat or water inlet assembly should you buy for your Jaguar F Type?

The biggest decision is whether to buy a bare thermostat, a thermostat-and-housing kit, or a complete water inlet assembly with the housing, seal, and sensor port already integrated. Many modern engines use a plastic water inlet assembly that bundles all of these components, so replacing the entire unit avoids a second coolant leak from a cracked old housing. Match the opening temperature rating to your vehicle's factory spec — using the wrong rating can cause the ECU to log fault codes or the engine to run outside its designed thermal range.

OEM-equivalent thermostat only
Best for
Vehicles with a reusable metal housing in good condition
What you get
Replacement valve at the factory-rated opening temperature; you reuse the existing housing and gasket
Thermostat + gasket kit
Best for
Older engines with a separate cast-iron or aluminum housing showing minor wear
What you get
Matched thermostat and multi-layer gasket or O-ring so both sealing surfaces renew at once
Complete water inlet assembly (thermostat integrated)
Best for
Modern engines with a plastic or composite housing — especially common on four-cylinder and turbocharged applications
What you get
One-piece unit with thermostat, housing, O-ring, and coolant temperature sensor port pre-installed; eliminates the housing as a future failure point
Performance / racing thermostat
Best for
Track or high-performance builds that run higher sustained loads and need a lower opening temperature for added cooling headroom
What you get
Lower-opening-temperature valve that moves coolant to the radiator sooner; not recommended for daily-driven vehicles in cold climates

Replacing an engine coolant thermostat or water inlet assembly on a Jaguar F Type

Easy | Moderate⏱ 1–2 hoursSocket set and ratchetPliers or hose clamp pliersDrain pan for coolantGasket scraper or pick (for metal housings)Funnel and coolant mixture for refill

Drain the cooling system until the level drops below the thermostat housing, then disconnect the hose clamp and hose, remove the housing bolts, and swap in the new thermostat or complete inlet assembly with a fresh seal or O-ring. Torque the housing bolts evenly and snugly following a crisscross pattern — over-tightening a plastic housing will crack it. Refill the system with the correct coolant, run the engine with the heater on full to purge air pockets, and check for leaks before returning the vehicle to service.

Frequently asked questions

How much does it cost to replace engine coolant thermostats on a Jaguar F Type?
Parts start at low prices on AutoBuffy. A bare thermostat or thermostat-and-gasket kit is typically on the lower end of the price range, while a complete water inlet assembly costs more because it includes the housing, O-ring, and integrated sensor port. Shop labor, if needed, generally adds one to two hours of shop time on top of the part cost.
Can I drive my Jaguar F Type with a faulty thermostat?
You should not drive with a thermostat stuck closed — the engine will overheat within minutes, risking a blown head gasket or warped cylinder head. A thermostat stuck open is less immediately dangerous, but the engine never reaches full operating temperature, which causes poor fuel economy, increased wear, and heater failure. Replace a failed thermostat promptly.
What causes a thermostat or water inlet assembly to fail on a Jaguar F Type?
The most common causes are age and corrosion. The wax pellet inside the thermostat hardens over time and loses the ability to expand and contract reliably. Electrolytic corrosion from old or unmaintained coolant can pit the valve seat and housing. On plastic water inlet assemblies, heat cycling eventually causes the housing to crack or the O-ring to harden and leak.
Is a P0128 code always caused by the thermostat on a Jaguar F Type?
A P0128 code — coolant temperature below thermostat regulating temperature — points to the thermostat as the most likely cause, typically a thermostat stuck open. However, a failed coolant temperature sensor sending inaccurate readings or low coolant level can trigger the same code. Test or replace the thermostat first, as it is the most common root cause.
Do I need to flush the coolant when I replace the thermostat or water inlet assembly on my Jaguar F Type?
It is good practice to do so. The system must be drained at least partially to remove the thermostat, and since the cooling system is already open, flushing removes degraded coolant and corrosion inhibitors that may have contributed to the original failure. Refill with the coolant type and concentration specified for your vehicle.
How do I know if the thermostat or the water pump is causing overheating on my Jaguar F Type?
A faulty thermostat stuck closed usually causes rapid overheating even at idle, and the upper radiator hose stays cool because coolant is not circulating to the radiator. A failing water pump typically causes overheating under load and often produces a whining noise or visible coolant weeping from the pump seal. Checking hose temperatures and listening for pump noise helps isolate the cause.

Engine coolant thermostat / water inlet assemblys for other Jaguar models

Jaguar XJRJaguar XKR-SJaguar XFR-SJaguar XK8Jaguar XJ8Jaguar XK