Loading...
Starting at $60.95, AutoBuffy stocks 1 Engine Variable Valve Timing (VVT) Solenoid Connectors from Standard Ignition. This connector delivers the electrical signal that tells the VVT solenoid when to advance or retard camshaft timing. A corroded or broken connector disrupts that signal, triggering rough idle, lost power, and a check engine light that won't clear until the wiring fault is fixed.
VVT solenoid connectors are matched by terminal count, wire gauge, and connector body shape — all of which vary by engine family. Verify the number of pins and the OEM connector style before ordering, since a close-but-wrong fitment will cause intermittent faults that are hard to diagnose. You can buy a bare connector (pigtail) or a pre-terminated repair harness depending on how much of the original wiring is damaged.
| Option | Best for | What you get |
|---|---|---|
| OEM-equivalent pigtail connector | Clean, localized damage at the connector body only | Factory-matched terminal count and locking tab design; splice directly to existing wires |
| Pre-terminated repair harness | Wiring damage that extends several inches back from the connector | Longer lead wires with heat-shrink splice connectors included; no exposed bare wire splices needed |
| Weatherproof sealed connector | Engines exposed to high moisture, oil mist, or extreme heat near the exhaust cam | Silicone-sealed terminals that resist corrosion and oil intrusion better than standard connectors |
| Connector + solenoid kit | When connector damage is caused by a shorted or oil-contaminated solenoid | Replaces both failure points at once, reducing the chance of a comeback repair |
Disconnect the battery before starting, then unplug the damaged connector from the solenoid and cut the wires cleanly a few inches back from the fault. Splice the new pigtail to the existing wiring using heat-shrink butt connectors, matching wire colors and polarity carefully, then apply dielectric grease to the terminals before seating the new connector. Reconnect the battery, clear any stored codes with a scan tool, and verify no codes return after a short test drive.