Loading...

Nissan Pulsar Nx Strut Bumper & Bellows Kits

Nissan Pulsar Nx Strut bumper & bellows kits

Starting at $17.95, AutoBuffy stocks 4 strut bumper and bellows kits from Monroe. The bump stop absorbs impact when the suspension fully compresses, while the bellows boot shields the strut shaft from dirt and moisture. When either fails, you risk metal-on-metal contact inside the strut and accelerated shaft wear that can destroy an otherwise good strut.

Signs your Nissan Pulsar Nx needs a new strut bumper and bellows kit

  • A sharp clunking or thudding sound over potholes or speed bumps, especially at full suspension compression
  • Visible cracks, tears, or collapse in the accordion-style rubber boot covering the strut shaft
  • Grease, grit, or corrosion buildup on the exposed strut rod where a torn boot no longer protects it
  • A bottoming-out sensation on rough roads even when the strut itself still functions
  • Squeaking or creaking from the front or rear suspension that worsens with temperature changes
  • Premature strut failure or leaking strut seals traced back to a contaminated or scored shaft

Which strut bumper and bellows kit should you buy for your Nissan Pulsar Nx?

The main decision is whether to buy the bump stop and boot as a combined kit or separately, and whether to match OE material grades or upgrade. Kits are generally the better value since the two components wear together and are always replaced at the same time. Make sure the kit is position-specific — front and rear units differ in length, diameter, and durometer.

OE-equivalent kit (rubber bump stop + rubber boot)
Best for
Daily drivers, stock ride height, restore-to-factory goal
What you get
Direct-fit replacement that matches original compression rate and shaft clearance; straightforward installation
Heavy-duty polyurethane bump stop + rubber boot
Best for
High-mileage vehicles, frequent rough-road use, or slightly lowered suspension
What you get
Firmer, more durable bump stop that resists compression set longer; stock boot keeps cost down
Complete quick-strut-compatible kit (extended bump stop + extended boot)
Best for
Lifted applications or vehicles with aftermarket springs taller than stock
What you get
Longer bump stop and boot sized for increased travel; prevents contact and boot bunching at full droop
Brand-matched OEM-supplier kit (e.g., from Monroe)
Best for
Owners who want engineering parity with the original part at lower cost than dealer
What you get
Same material specs and dimensions as the factory part, often sourced from the same supply chain; includes both components in one box

Strut bumper & bellows kits brands we stock for your Nissan Pulsar Nx

Monroe
4 options · from $17.95

Replacing a strut bumper and bellows kit on a Nissan Pulsar Nx

Moderate⏱ 1.5–3 hours per axleQuality coil spring compressor (rental or purchase — do not skip)Socket and ratchet set with metric and SAE sizesTorque wrenchPry bar or trim tool for boot positioningPenetrating oil for corroded strut hardware

Remove the strut from the vehicle, then use a coil spring compressor to safely relieve spring tension before disassembling the strut. Slide off the old boot and bump stop, transfer the new components onto the strut shaft, and reassemble in reverse order, making sure the spring seats correctly. Torque all fasteners to manufacturer specification — consult a service manual for your specific Nissan Pulsar Nx — and have the alignment checked after reinstallation.

Frequently asked questions

How much does it cost to replace strut bumper and bellows kits on a Nissan Pulsar Nx?
Parts start at $17.95 per kit on AutoBuffy. Most owners buy kits in pairs (both fronts or both rears) for even wear. If a shop installs them during a strut replacement, labor is minimal since the strut is already disassembled. Standalone boot-and-bump-stop replacement at a shop typically runs one to two hours of labor per axle.
Can I drive my Nissan Pulsar Nx with a torn strut boot or collapsed bump stop?
You can drive short distances, but it is not advisable. A torn bellows immediately exposes the strut shaft to road grit, water, and salt, accelerating shaft scoring and seal wear. A collapsed bump stop allows metal-to-metal contact inside the strut housing. Either condition can destroy a functional strut within months, turning a low-cost fix into a full strut replacement.
Do I need to replace the bump stop and bellows boot together on my Nissan Pulsar Nx?
Yes, in almost every case. The two parts share the same service life and fail for the same reasons — UV exposure, ozone cracking, and compression fatigue. Replacing only one leaves the other vulnerable to imminent failure. Kits bundle both components and cost only marginally more than buying a boot alone, making the combined replacement the clear practical choice.
Is replacing a strut bumper and bellows kit something I can do myself on my Nissan Pulsar Nx?
It is a moderate DIY job. The strut must be removed and disassembled with a spring compressor to access the bump stop and boot. If you already own or can rent a quality coil spring compressor and have basic mechanical experience, the job is manageable in a home garage. Without a spring compressor, the job should go to a shop — compressed coil springs are dangerous.
How long do strut bumper and bellows kits last on a Nissan Pulsar Nx?
Service life varies widely based on climate, road conditions, and rubber quality, but most OE-style kits last several years to well over a decade. Northern climates with road salt and freeze-thaw cycles shorten boot life significantly. Inspecting the boot and bump stop whenever tires are rotated or brakes are serviced catches failures before they damage the strut shaft.
Will replacing just the bump stop and boot fix the clunking noise in my Nissan Pulsar Nx's suspension?
If the noise is a sharp thud at full compression, a collapsed bump stop is the likely cause and replacing the kit often resolves it. However, clunking can also indicate worn strut mounts, damaged strut internals, or loose sway bar links. Inspect those components at the same time so you do not reinstall new boots on a worn strut assembly that still needs replacement.

Shop strut bumper & bellows kits by year for the Nissan Pulsar Nx

19901989198819871986198519841983

More parts for your Nissan Pulsar Nx

Alternator Brush SetBrake Pad & Rotor KitIgnition Lock Cylinder and SwitchBarometric Pressure Sensor ConnectorAir Charge Temperature Sensor ConnectorEngine Cooling Fan SwitchEngine Oil Pan GasketBrake Hardware Kit

Strut bumper & bellows kits for other Nissan models

Nissan 280ZNissan 810Nissan TsubameNissan CubeNissan PulsarNissan 200SX