Loading...

Plymouth Neon Power Steering Pressure Switchs

Plymouth Neon Power steering pressure switchs

Starting at $54.95, AutoBuffy stocks 1 power steering pressure switches from Standard Ignition for the Plymouth Neon. This switch monitors hydraulic pressure in the power steering system and signals the engine control module to raise idle speed under high steering load. A failed switch causes rough idle, stalling during low-speed turns, or a permanently lit warning light.

Signs your Plymouth Neon needs a new power steering pressure switch

  • Engine stalls or nearly stalls when turning the steering wheel at low speeds or while parking
  • Idle speed drops noticeably the moment steering load increases, then recovers when you straighten out
  • Power steering warning light or check engine light is illuminated and a pressure switch fault code is stored
  • Rough, hunting idle at stops — worse when the steering wheel is held at full lock
  • Visible power steering fluid seeping or dripping from the switch body or its electrical connector port
  • Idle compensation works on some turns but not others, pointing to an intermittent switch signal

Which power steering pressure switch should you buy for your Plymouth Neon?

The main decision is matching the switch's pressure rating and connector type to your Plymouth Neon's exact power steering system. Some Neon applications use a single-wire on/off switch; others use a multi-wire variable-pressure sensor — fitting the wrong one will cause codes or no idle compensation at all. Brand quality and sealing material are secondary but matter for longevity.

OEM-equivalent (exact fit)
Best for
Owners who want plug-and-play installation with no calibration and the longest service life
What you get
Matched pressure threshold, correct connector, and factory-grade sealing — zero fitment risk
Standard aftermarket
Best for
Budget-conscious owners doing a straightforward replacement on a daily driver
What you get
Acceptable pressure ratings and sealing at a lower price; quality varies by brand
Heavy-duty / high-pressure rated
Best for
Plymouth Neon applications with an upgraded or high-output power steering pump, or vehicles used for towing
What you get
Higher burst and operating pressure tolerance to prevent premature failure under extra hydraulic stress
Remanufactured
Best for
Cost-sensitive repairs where the original switch body and thread size must be preserved
What you get
Core is rebuilt to spec and pressure-tested; usually includes a warranty but may have limited brand selection

Power steering pressure switchs brands we stock for your Plymouth Neon

Standard Ignition
1 option · from $54.95

Replacing the power steering pressure switch on a Plymouth Neon

Easy30–60 minutesFlare-nut or open-end wrench (sized to switch hex)Socket set and ratchetThread seal tape (PTFE) if not pre-appliedShop rags and a small drain panOBD-II scan tool to clear fault codes

Locate the power steering pressure switch on the high-pressure line or pump body, disconnect the electrical connector, and use the correct wrench size to unthread the old switch while catching any fluid that drains out. Thread in the new switch by hand first to avoid cross-threading, then snug it firmly — overtightening can crack the switch body or damage the line fitting. Reconnect the connector, top off the power steering fluid if needed, start the engine, and clear any stored codes before test-driving.

Frequently asked questions

How much does it cost to replace power steering pressure switches on a Plymouth Neon?
Parts alone start at $54.95 for the Plymouth Neon. Add $50–$120 in shop labor if you're not doing it yourself, since the job typically takes under an hour once the switch is located. Total out-of-pocket for a professional replacement usually runs well under $200, making it one of the more affordable power steering repairs.
Can I drive my Plymouth Neon with a bad power steering pressure switch?
You can drive short distances, but it carries real risk. Without proper idle compensation, the engine can stall mid-turn at low speed — a hazard in parking lots and intersections. Fluid leaking from a failed switch can also drip onto hot exhaust components. Replace it promptly rather than treating it as a deferred item.
Will a faulty power steering pressure switch trigger a check engine light on a Plymouth Neon?
Yes. The ECM monitors the signal from the pressure switch, and an open circuit, short, or out-of-range voltage will set a diagnostic fault code and illuminate the check engine light. Clearing the code without replacing the switch will cause it to return. Scan for codes first to confirm the switch is the root cause before purchasing parts.
How do I know if the power steering pressure switch is bad or if the pump is failing on my Plymouth Neon?
A bad switch typically causes idle and stalling complaints with normal steering feel and no whining noise. A failing pump usually produces a whining or groaning sound, heavy steering effort, and low fluid pressure across all conditions. Check for fault codes first — a switch failure almost always stores a code, while pump wear often does not.
Is replacing a power steering pressure switch on a Plymouth Neon a DIY job?
For most Neon owners with basic mechanical experience, yes. The switch threads into the high-pressure line or pump body and uses a single connector. The main challenges are access in tight engine bays and avoiding fluid spillage during removal. Depressurize the system, have rags ready, and torque the new switch to snug-plus-firm without over-tightening the threads.
Does the power steering pressure switch need to be programmed or calibrated after replacement on a Plymouth Neon?
No programming or calibration is required. The switch is a passive pressure-sensitive device — once it is installed and the connector is seated, the ECM reads it immediately. Clear any stored fault codes after installation, start the engine, and verify the idle stabilizes normally when turning the steering wheel to confirm correct operation.

Shop power steering pressure switchs by year for the Plymouth Neon

More parts for your Plymouth Neon

Power steering pressure switchs for other Plymouth models