Loading...
Starting at $3.95, AutoBuffy stocks 1 starter drive shaft retainer packs from Standard Ignition. This small clip or circlip assembly locks the drive shaft inside the starter motor, preventing axial movement during engagement. When it fails, the drive gear can't transfer torque cleanly to the flywheel, causing no-start conditions, grinding, or a freewheeling starter that spins without cranking the engine.
The retainer pack must match the exact shaft diameter and groove geometry of your Pontiac Parisienne's starter motor — a millimeter of mismatch means it won't seat and won't hold under load. Packs typically differ by clip style (circlip vs. snap ring vs. roll pin) and whether they include the thrust washer and stop collar needed to complete a full rebuild. Buying the OE-spec kit rather than a loose clip alone is almost always worth the small price difference.
| Option | Best for | What you get |
|---|---|---|
| OE-Spec Retainer Pack | Reliability-focused owners who want factory fit and confirmed engagement force | Circlip or snap ring stamped to original thickness and hardness specs, often with matching thrust washer |
| Full Starter Rebuild Kit (includes retainer) | DIYers rebuilding an otherwise sound starter to avoid buying a complete unit | Retainer, thrust washers, stop collar, brushes, and sometimes a new solenoid contact — one box covers the whole job |
| Universal Circlip Assortment | Shops or owners who need an immediate fix and can measure the groove diameter precisely | Multiple clip sizes in one pack; requires careful measurement to select the correct clip — lowest cost but highest fitment risk |
| OEM Replacement Pack (dealer-sourced) | Vehicles still under powertrain warranty or where exact part traceability is required | Brand-matched clip assembly with documented tolerances; highest cost but zero guesswork on groove fit for the Pontiac Parisienne |
Remove the starter from the Pontiac Parisienne, disconnect the solenoid wiring, and disassemble the drive end housing to expose the shaft and retainer groove. Use the correct snap ring pliers to remove the old clip without scoring the groove, seat the new retainer fully until it clicks into the groove with no gap, then reassemble and verify there is minimal axial shaft play before reinstalling the unit. Torque the mounting hardware to the manufacturer's specification range for the Pontiac Parisienne and confirm clean starter engagement with several test cranks before closing up.