Loading...
Engine oil pump seal kits for your Volvo S70 start at low prices, with multiple kits in stock from top OE-quality brands. The oil pump seal kit replaces the worn gaskets and O-rings that keep pressurized oil from leaking at the pump housing. When these seals fail, oil pressure drops and internal engine components lose critical lubrication — leading to accelerated wear or engine damage if ignored.
The most important buying decision is whether the kit contains every seal, O-ring, and gasket required for your specific oil pump — a partial kit may leave an old seal in place that fails shortly after the repair. You should also consider seal material, since rubber compound quality directly affects how long the kit lasts under heat and oil exposure.
| Option | Best for | What you get |
|---|---|---|
| OEM-equivalent complete kit | Drivers who want a factory-correct repair with all seals included | Full set of seals, O-rings, and gaskets matched to OEM dimensions and durometer |
| Performance/high-temp kit | High-mileage engines, towing applications, or modified engines running higher oil temps | Upgraded Viton or PTFE seals rated for elevated heat and pressure beyond stock tolerances |
| Oil pump housing gasket + seal combo | Engines where only the housing-to-block mating surface is leaking, not the shaft seal | Housing gasket and select O-rings without the full seal set — lower cost but narrower coverage |
| Master engine seal kit (includes oil pump seals) | Engine rebuilds or high-mileage restorations where multiple seal points need replacement at once | Oil pump seals bundled with timing cover, crankshaft, and camshaft seals for a comprehensive refresh |
Replacing the oil pump seal kit on a Volvo S70 typically requires draining the oil, removing the harmonic balancer and front cover to expose the pump, then carefully removing and replacing each seal and O-ring without nicking sealing surfaces. All mating surfaces must be thoroughly cleaned before installation, and new seals should be lightly lubricated with clean engine oil to prevent tearing during assembly. Reassemble in reverse order and verify oil pressure returns to the normal operating range before returning the vehicle to service.