Loading...

Volvo V70 Turn Signal / Parking Light Assemblys

Volvo V70 Turn signal / parking light assemblys

Turn signal / parking light assemblies for the Volvo V70 start at low prices. We carry multiple assemblies from top OE-quality brands. These units house the amber or clear lenses and bulb sockets that signal turns and mark the vehicle's width when parked. A cracked, faded, or water-damaged assembly triggers failed inspections, confuses other drivers, and can draw a fix-it ticket.

Signs your Volvo V70 needs a new turn signal / parking light assembly

  • Turn signal blinks faster than normal (hyper-flash) with no bulb burned out — the lens or socket has an internal short or poor ground
  • Lens is visibly cracked, shattered, or has a large chip that exposes the bulb to moisture and road debris
  • Water or condensation pools inside the housing, causing bulb corrosion and intermittent signal failure
  • Amber or clear lens has yellowed, hazing, or melted from heat, reducing light output below legal limits
  • Parking light stays dark even after replacing the bulb, pointing to a failed socket or broken wiring tab inside the assembly
  • Assembly is loose or rocking because the mounting tabs broke off, risking the unit falling out at speed

Which turn signal / parking light assembly should you buy for your Volvo V70?

The main choice is between OE-equivalent replacement assemblies and upgraded LED or projector-style units. Position matters too — front corner assemblies, rear combination units, and side-marker versions are not interchangeable. Confirm the exact side (driver or passenger) and mounting location before ordering.

OE-Replacement (halogen-ready)
Best for
Daily drivers and budget repairs
What you get
Direct plug-and-play fit, standard amber or clear lens, accepts factory bulbs — no hyper-flash issues
LED Conversion Assembly
Best for
Drivers wanting brighter, longer-lasting signals
What you get
Integrated LED array, faster activation time, longer service life — may require a load resistor to prevent hyper-flash on older vehicles
Smoked / Tinted Lens Assembly
Best for
Appearance-focused builds
What you get
Dark lens that reduces visible amber tint at rest; legal only if light output still meets DOT minimum brightness requirements
Combination Turn + Parking + Daytime Running Unit
Best for
Vehicles with multi-function front corner assemblies
What you get
Single housing replaces turn, parking, and DRL circuits together; eliminates multiple part purchases

Replacing the turn signal / parking light assembly on a Volvo V70

Easy20–45 minutesFlathead screwdriver or trim panel toolPhillips head screwdriverSocket and ratchet set (metric or SAE depending on vehicle)Needle-nose pliers (for bulb socket release clips)

Most exterior turn signal and parking light assemblies are secured by two to four bolts or screws accessible from inside the engine bay, trunk, or behind a trim panel — no cutting or splicing required. Disconnect the bulb socket harness, remove the fasteners, pull the old assembly free, transfer any retained hardware, and seat the new unit until the mounting tabs click or until fasteners are snug. Reconnect the harness, install fresh bulbs if needed, and verify operation before closing any panels.

Frequently asked questions

How much does it cost to replace turn signal / parking light assemblies on a Volvo V70?
Parts start at low prices for the Volvo V70. A basic OE-style replacement is on the lower end of that range; LED or combination assemblies cost more. DIY installation adds nothing beyond basic tools. A shop will typically bill 0.5–1 hour of labor on top of the part price for straightforward exterior assemblies.
Can I drive my Volvo V70 with a broken turn signal assembly?
No. A non-functioning or damaged turn signal assembly is illegal in every U.S. state and most countries. Other drivers cannot anticipate your intentions, significantly raising accident risk. You also face fix-it citations and possible liability in a collision. Replace or at minimum seal a cracked housing with clear lens tape until the part arrives.
Will a new turn signal assembly come with bulbs for my Volvo V70?
Most OE-style replacement assemblies do not include bulbs — they are sold separately. LED assemblies typically have integrated LEDs and need no separate bulb. Always check the product listing before ordering so you have the correct bulb type on hand for a single-visit repair.
Why does my Volvo V70 hyper-flash after installing a new LED assembly?
Hyper-flash happens because the turn signal flasher reads LED draw as a burned-out bulb and speeds up the blink rate. Fix it by adding an inline load resistor matched to your circuit, or by replacing the factory thermal flasher with an electronic LED-compatible flasher relay. This is a wiring change, not a defect in the assembly itself.
How do I keep moisture from building up inside my Volvo V70's new turn signal assembly?
Ensure the rubber gasket or foam seal on the housing lip is fully seated before reinstalling. Do not overtighten mounting hardware, which can crack the tab and break the seal. If the assembly has a vent tube, confirm it is clear and pointing downward. Avoid pressure-washing directly at the lens seam.
Is the driver-side and passenger-side turn signal assembly the same part for the Volvo V70?
No. Driver-side and passenger-side assemblies are mirror images of each other and are separate part numbers. Ordering the wrong side is one of the most common return reasons. Double-check which corner is damaged before adding to cart, and verify the part description explicitly states the correct side.

More parts for your Volvo V70

Turn signal / parking light assemblys for other Volvo models