Loading...

Acura Tl Engine Oil Pressure Switchs

Acura Tl Engine oil pressure switchs

Starting at $6.95, AutoBuffy stocks 11 engine oil pressure switches from Standard Ignition, VEMO, and GPD to fit your Acura Tl. The oil pressure switch monitors lubrication pressure and signals the gauge or warning light on your dash. When it fails, you lose that warning system entirely — risking undetected low oil pressure that can destroy an engine in minutes.

Signs your Acura Tl needs a new engine oil pressure switch

  • Oil pressure warning light stays on at idle or while driving even after confirming oil level is correct and full
  • Oil pressure gauge reads zero, pegs at maximum, or fluctuates erratically with no change in engine behavior
  • Warning light flickers or pulses in sync with engine RPM, especially noticeable at low speeds
  • Visible oil seepage or wet residue around the switch body or its connector on the engine block
  • Oil pressure light goes off only after revving the engine above idle, then returns when RPMs drop
  • Scan tool or code reader shows a P0520, P0521, or related oil pressure sensor circuit fault code

Which engine oil pressure switch should you buy for your Acura Tl?

The most important buying decision is matching the switch to your Acura Tl's specific circuit type — some switches are simple on/off senders for a warning light, while others are variable-resistance senders that drive an analog gauge, and mixing them up produces incorrect readings. Thread pitch and port size must also match exactly, since undersized or oversized threads will leak under pressure.

OEM-equivalent replacement
Best for
Restoring factory function with guaranteed fit and calibration
What you get
Correct thread pitch, pressure threshold, and connector type matched to your Acura Tl's original specification
Warning-light type (on/off switch)
Best for
Acura Tl equipped with a simple oil pressure warning light and no gauge
What you get
Single-circuit switch that closes or opens at a fixed pressure threshold to trigger the dash light only
Variable-resistance sender
Best for
Acura Tl with a factory analog oil pressure gauge on the instrument cluster
What you get
Multi-value resistive sender that varies signal across a range so the gauge needle moves proportionally
Dual-function switch
Best for
Acura Tl that uses both a warning light and an analog gauge on the same port
What you get
Two circuits in one housing — one fixed-threshold circuit for the warning light, one variable circuit for the gauge

Engine oil pressure switchs brands we stock for your Acura Tl

Standard Ignition
3 options · from $6.95
VEMO
3 options · from $9.95
GPD
2 options · from $8.95
ACDelco
1 option · from $25.95
Autotecnica
1 option · from $62.95
Beck/Arnley
1 option · from $7.95

Replacing the engine oil pressure switch on a Acura Tl

Easy⏱ 30–60 minutesOil pressure switch socket (dedicated crowfoot-style socket sized for the switch hex)Ratchet and short extensionDrain pan and shop ragsThread sealant or PTFE tape rated for oilElectrical contact cleaner for the connector

Let the engine cool before starting — the switch is threaded directly into the engine block or oil filter housing where pressurized hot oil is present. Disconnect the electrical connector, unthread the old switch with the correct socket, and immediately plug the port with a clean rag to minimize oil spillage. Apply fresh thread sealant to the new switch, thread it in by hand to avoid cross-threading, snug it firmly without over-tightening, reconnect the harness, then start the engine and check for leaks before clearing any warning lights.

Frequently asked questions

How much does it cost to replace engine oil pressure switches on a Acura Tl?
The part itself starts at $6.95 at AutoBuffy. Total DIY cost is usually just the switch plus a small amount of thread sealant. A shop will add one to two hours of labor on top of the part price, though most technicians complete the swap in under an hour depending on how accessible the switch is on your Acura Tl's engine.
Can I drive my Acura Tl with a bad oil pressure switch?
You should not drive far or for long with a suspected bad oil pressure switch. Until you confirm the switch is the fault and not actual low oil pressure, treat the warning as real. Driving with genuinely low oil pressure even for a short distance can cause severe, irreversible engine bearing and camshaft damage on a Acura Tl.
How do I know if the problem is the switch or actual low oil pressure on my Acura Tl?
First verify the oil level on the dipstick is correct. Then connect a mechanical oil pressure gauge to the sending unit port and check pressure at idle and at higher RPMs. If mechanical pressure is within the normal operating range for your Acura Tl but the dash light or gauge still misbehaves, the switch itself is the likely culprit.
Will a bad oil pressure switch cause my Acura Tl to run poorly or stall?
A faulty oil pressure switch on most Acura Tl applications does not directly affect engine operation or fuel delivery. However, some Acura engines use the oil pressure signal as an input to the fuel pump circuit, meaning a failed switch can actually shut off the fuel pump and stall the engine. Check your specific wiring diagram before assuming it is only a gauge issue.
How long does an engine oil pressure switch last on a Acura Tl?
Oil pressure switches generally last many years and tens of thousands of miles, but they are exposed to engine heat cycles, vibration, and oil contamination constantly. Failure is more common on higher-mileage Acura Tl engines where oil sludge or pressure fluctuations stress the switch diaphragm. Replacing it during an oil leak repair or sensor-related diagnostic is inexpensive preventive maintenance.
Do I need thread sealant when installing an oil pressure switch on my Acura Tl?
Yes, in most cases. Oil pressure switch threads are typically tapered pipe threads (NPT) that require thread sealant or PTFE tape to seal against oil leakage — they do not seal on a crush washer the way a drain plug does. Use a sealant rated for petroleum and heat, apply it carefully, and avoid getting any inside the port where it could block the pressure sensing hole.

Shop engine oil pressure switchs by year for the Acura Tl

20142013201220112010200920082007200620052004200320022001200019991998199719961995

More parts for your Acura Tl

Engine Cooling Fan AssemblyFuel Injector KitSuspension KitFuel Injector ConnectorPower Steering HoseA/C Condenser Fan Motor RelayVehicle Speed Sensor ConnectorSerpentine Belt

Engine oil pressure switchs for other Acura models

Acura CSXAcura RSXAcura ELAcura MDXAcura SLXAcura RL