Loading...
Starting at low prices, AutoBuffy stocks multiple ignition lock cylinder and switch options for the Acura Tl from trusted brands including top OE-quality brands. The ignition lock cylinder accepts your key and mechanically engages the ignition switch, which sends electrical signals to start the engine and power accessories. When either component fails, the vehicle may not start or may lose power unexpectedly.
The ignition lock cylinder and the ignition switch are two separate parts that are often sold together or individually — confirm which component has failed before ordering. The main decisions are whether you need a pre-coded (passkey/transponder-compatible) unit or a standard mechanical cylinder, and whether you want a direct OE-replacement or an aftermarket value option.
| Option | Best for | What you get |
|---|---|---|
| OE-Replacement Cylinder + Switch Assembly | Owners who want a single, plug-and-play fix with correct fitment | Matched cylinder and switch sold as one unit; retains factory wiring connector and anti-theft provisions |
| Lock Cylinder Only (no switch) | Vehicles where the electrical switch tests good but the mechanical cylinder is worn or the key no longer turns | Replacement tumbler assembly only; less expensive when the switch itself is not at fault |
| Ignition Switch Only (no cylinder) | Vehicles with electrical symptoms — cutting out, no crank — where the key and cylinder physically operate correctly | Electrical switch module that mounts behind the cylinder; addresses no-start and accessory loss issues |
| Coded / Transponder-Compatible Unit | Vehicles equipped with a passkey, VATS, or immobilizer anti-theft system | Pre-coded or codeable cylinder designed to work with the Acura Tl anti-theft system; may require dealer or locksmith programming after install |
Replacing the ignition lock cylinder on a Acura Tl typically requires removing the steering column shroud panels to access the cylinder housing, then depressing a small release tab — usually with a pin punch — while the key is in the accessory position to slide the old cylinder out. The ignition switch module, which mounts just behind the cylinder on the column, is usually secured by one or two screws and unplugs from the wiring harness. Reassemble in reverse order, and test all ignition positions and accessories before reinstalling trim panels.