Loading...

Buick Regal Tie Rod Ends

Buick Regal Tie rod ends

Tie rod ends for your Buick Regal start at $6.95, and AutoBuffy stocks 133 options from Delphi, Mevotech Supreme, and MOOG. A tie rod end is the pivot point connecting your steering rack to the wheel hub — it transmits your steering input directly to the wheel. When it wears out, steering becomes imprecise and tire wear accelerates, making prompt replacement a safety priority.

Signs your Buick Regal needs new tie rod ends

  • Loose, wandering steering — the Buick Regal drifts or requires constant small corrections to track straight
  • Clunking or knocking from the front end when turning or hitting small bumps at low speed
  • Uneven or feathered tire wear on the inside or outside edge of the front tires
  • Vibration felt through the steering wheel, especially noticeable at highway speeds
  • Visible play or slop when you grab the front tire at 9 and 3 o'clock and rock it side to side with the wheel off the ground
  • Front-end alignment goes out of spec repeatedly or cannot be properly set

Which tie rod end should you buy for your Buick Regal?

The two main decisions are position — inner vs. outer tie rod end — and quality grade. Inner tie rod ends thread into the steering rack and are usually replaced less often; outer ends are exposed to more road debris and wear faster. Matching the correct side and position for your Buick Regal is essential before comparing brands.

OE Replacement (Economy grade)
Best for
Budget-conscious repairs, older high-mileage Buick Regals
What you get
Meets original specs at the lowest cost; acceptable lifespan for everyday driving
OE Replacement (Premium grade)
Best for
Daily drivers and vehicles kept long-term
What you get
Upgraded seals and grease retention, tighter tolerances, longer service life than economy parts
Greaseable tie rod end
Best for
Buick Regals in harsh climates or off-road use
What you get
Zerk fitting allows periodic re-greasing, significantly extending joint life in mud, salt, or dust
Heavy-duty / Performance tie rod end
Best for
Lifted, modified, or performance-oriented Buick Regals
What you get
Reinforced construction and higher load ratings to handle suspension lifts or aggressive driving

Tie rod ends brands we stock for your Buick Regal

Delphi
19 options · from $15.95
Mevotech Supreme
17 options · from $8.95
MOOG
17 options · from $25.95
Mevotech Original Grade
16 options · from $6.95
Suspensia
16 options · from $10.95
Detroit Axle
13 options · from $32.95
ACDelco
11 options · from $19.95
Dorman
7 options · from $18.95
SKP
7 options · from $8.95
Vaico
6 options · from $18.95
SKF
3 options · from $16.95
GM Genuine Parts
1 option · from $105.95

Replacing tie rod ends on a Buick Regal

Moderate1–2 hours per sideTie rod end separator or pickle forkWrench set and socketsTorque wrenchNeedle-nose pliers (for cotter pin)Measuring tape or paint marker (to record thread depth before removal)

Before removing the old outer tie rod end on your Buick Regal, count and record the exact number of exposed threads so the new end can be threaded in to the same depth — this preserves approximate toe alignment until a proper alignment can be done. The castle nut and cotter pin at the knuckle must be replaced, and the taper seat requires a separator tool to pop free cleanly. A professional wheel alignment is required after installation regardless of how closely the thread count was matched.

Frequently asked questions

How much does it cost to replace tie rod ends on a Buick Regal?
Parts for your Buick Regal start at $6.95 at AutoBuffy. Plan to replace both sides together to maintain even steering feel. Add shop labor of roughly one to two hours per side if you are not doing the work yourself, plus a mandatory wheel alignment after any tie rod replacement.
Do I need a wheel alignment after replacing tie rod ends on a Buick Regal?
Yes — a four-wheel alignment is required any time a tie rod end is replaced on a Buick Regal. Tie rod adjustment directly controls toe angle. Even if the new part threads in to the same depth as the old one, toe will almost certainly be off enough to cause rapid tire wear and handling problems without a fresh alignment.
Should I replace both inner and outer tie rod ends at the same time on my Buick Regal?
It is strongly recommended. If the outer end has failed, the inner end on the same side has experienced the same miles and road stress. Replacing both together saves labor since the steering rack area is already disassembled, avoids a second alignment charge shortly after, and restores the full steering linkage on that side.
How long do tie rod ends last on a Buick Regal?
Lifespan varies widely based on road conditions, driving style, and whether the boots remain intact. On typical roads, tie rod ends commonly last many years, but vehicles driven in salted or unpaved conditions often see them wear out significantly sooner. Inspect the boots and check for play at every tire rotation.
Can I drive my Buick Regal with a bad tie rod end?
No — a worn or failing tie rod end is a serious safety hazard and the Buick Regal should not be driven until it is repaired. A severely worn joint can separate completely, causing an immediate and total loss of steering control. If you notice clunking, wandering, or visible play in the front end, have it inspected immediately.
How do I know if my Buick Regal has a bad inner or outer tie rod end?
With the front wheels on the ground, have a helper rock the steering wheel slightly while you watch and feel the steering linkage. Outer tie rod end play appears at the knuckle connection and is visible without removing components. Inner tie rod wear is felt as slop where the rod connects to the rack, often detected by reaching past the bellows boot.

Shop tie rod ends by year for the Buick Regal

More parts for your Buick Regal

Tie rod ends for other Buick models