Loading...
Starting at low prices, AutoBuffy stocks multiple wheel bearing kits for the Jaguar Xkr S from brands including top OE-quality brands. A wheel bearing kit allows your wheel to spin freely with minimal friction while keeping it precisely located on the hub. When a bearing fails, it creates noise, vibration, and — if ignored — can allow dangerous wheel play or complete wheel separation.
The most important decision is whether you need a press-in bearing kit — which requires a hydraulic press to install — or a bolt-on hub assembly kit that includes the bearing pre-packed and pre-pressed into the hub. Beyond that, consider bearing grade and whether your Jaguar Xkr S uses a serviceable tapered roller bearing (common on rear axles and older front axles) or a sealed, non-serviceable unit bearing. Always replace both sides of an axle at the same time if one is showing wear.
| Option | Best for | What you get |
|---|---|---|
| OE-Grade Sealed Hub Assembly Kit | Drivers who want a direct bolt-on replacement with no press work | Pre-packed, pre-pressed sealed bearing bonded to hub flange; includes ABS tone ring where applicable; closest match to factory spec |
| Press-In Bearing Kit (Race & Bearing Set) | Shop installs or experienced DIYers with a hydraulic press | Inner/outer bearing races plus sealed or greaseable bearing; lower part cost but requires knuckle to be pressed in a shop |
| Tapered Roller Bearing Kit | Rear axles, older front axles, and tow-duty applications requiring adjustable preload | Separate inner cone, outer cone, and races; allows preload adjustment and periodic re-greasing; more durable under heavy load |
| Heavy-Duty / Performance Upgrade Kit | High-mileage vehicles, towing/hauling, or off-road use on the Jaguar Xkr S | Higher load-rating bearings with thicker races and premium grease seals; extended service life under stress compared to standard OE replacement |
Bolt-on hub assembly kits are the more accessible option — after removing the wheel, brake caliper, and rotor, the old hub unbolts from the knuckle and the new unit bolts directly in place. Press-in bearing kits require the steering knuckle to be removed from the vehicle and taken to a shop with a hydraulic press to remove the old races and press in the new bearing without damaging the knuckle bore. In either case, always consult the Jaguar Xkr S service manual for proper fastener torque sequences, and verify ABS sensor connector orientation before final assembly.