Loading...

Chevrolet Corsica Manual Transmission Mount Bushings

Chevrolet Corsica Manual transmission mount bushings

Manual transmission mount bushings for your Chevrolet Corsica start at $9.95, and AutoBuffy stocks 2 options from DEA. The bushing is the rubber or polyurethane insert inside the transmission mount that absorbs vibration and holds the transmission in precise alignment. When it fails, you get harsh vibration, clunking during shifts, and driveline stress that can damage adjacent components.

Signs your Chevrolet Corsica needs new manual transmission mount bushings

  • Clunking or thudding noise when engaging or releasing the clutch
  • Excessive vibration felt through the shifter, floor, or seat at idle or under acceleration
  • Transmission visibly shifting or rocking when you rev the engine with the hood open
  • Hard or vague gear engagement caused by the transmission moving out of its normal position
  • Squeaking or creaking from under the vehicle when the drivetrain loads and unloads
  • Visible cracking, tearing, or complete separation of the rubber bushing material on inspection

Which manual transmission mount bushing should you buy for your Chevrolet Corsica?

The main decision is material: OEM-style rubber bushings restore stock NVH comfort, while polyurethane bushings offer firmer, more precise transmission location at the cost of slightly more felt vibration. You also need to confirm whether your Chevrolet Corsica uses a single transmission mount bushing or separate front and rear bushings, as some platforms require replacing them as a set.

OEM-grade rubber
Best for
Daily drivers prioritizing a quiet, factory-feel ride
What you get
Original vibration damping, easy installation, direct-fit replacement
Polyurethane (street)
Best for
Performance-oriented daily drivers and weekend drivers
What you get
Firmer transmission location, longer wear life, minor NVH increase over rubber
Polyurethane (solid/race)
Best for
Track or competition vehicles where NVH is not a concern
What you get
Maximum transmission rigidity, zero bushing flex, significantly increased cabin vibration
Bushing rebuild kit
Best for
DIYers reusing the existing mount bracket in good condition
What you get
Replacement inserts only, lower cost, requires pressing old bushing out of the bracket

Manual transmission mount bushings brands we stock for your Chevrolet Corsica

DEA
2 options · from $9.95

Replacing manual transmission mount bushings on a Chevrolet Corsica

Moderate⏱ 1–2 hoursFloor jack and jack standsSocket and ratchet setBreaker bar or impact wrenchBushing press or hydraulic press (if pressing inserts)Penetrating oil (for corroded hardware)

Support the transmission with a jack before removing the mount bolts so it does not drop when the bushing is freed. Once the mount is out, press or drive the old bushing from the bracket and seat the new bushing fully before reinstalling. Torque all mount hardware to the manufacturer's specification and remove the transmission jack only after all fasteners are secured.

Frequently asked questions

How much does it cost to replace manual transmission mount bushings on a Chevrolet Corsica?
Parts start at $9.95 for a Chevrolet Corsica bushing or bushing set. DIY total cost is typically just the part plus any penetrating oil or press rental. Shop labor for this job generally runs one to two hours, so expect a combined professional repair cost noticeably higher than the part price alone.
Can I drive my Chevrolet Corsica with a worn transmission mount bushing?
Short trips are possible, but it is not advisable. A failed bushing allows the transmission to shift under load, which accelerates wear on the driveshaft, shifter linkage, and clutch components. Continued driving also risks the mount bracket cracking or the transmission contacting the chassis, turning a low-cost repair into a major one.
How long do manual transmission mount bushings last on a Chevrolet Corsica?
Rubber bushings typically last anywhere from 50,000 to over 150,000 miles depending on driving style, climate, and exposure to oil or road chemicals. Aggressive driving, high heat, and oil contamination from leaks all significantly shorten bushing life. Polyurethane bushings generally outlast rubber under the same conditions.
Do I need to replace the entire transmission mount or just the bushing on my Chevrolet Corsica?
It depends on the condition of the bracket. If the metal bracket is straight and free of cracks, replacing only the bushing insert is a cost-effective solution. If the bracket is bent, cracked, or the bushing has been worn long enough to damage the metal, replacing the complete mount assembly is the safer choice.
Is replacing a manual transmission mount bushing on a Chevrolet Corsica a DIY job?
Most experienced DIYers can handle it with basic hand tools, a jack, and jack stands. The main challenge is pressing the old bushing out of the bracket, which may require a hydraulic press or a bushing press tool. If the mount is accessible without dropping the transmission, difficulty stays in the moderate range.
Will a stiffer polyurethane bushing cause noticeable vibration inside my Chevrolet Corsica?
Yes, polyurethane transmits more engine and drivetrain vibration into the cabin than rubber because it does not absorb as much energy. On a daily-driven Chevrolet Corsica, this usually means a slight buzz felt through the floor or shifter at idle. For most drivers the trade-off is acceptable; for those sensitive to NVH, OEM rubber is the better choice.

Shop manual transmission mount bushings by year for the Chevrolet Corsica

19961995199419931992

More parts for your Chevrolet Corsica

Steering Tie Rod BushingTransmission Oil PanEngine Air Intake HoseEngine Cooling Fan AssemblyMixture Control Solenoid ConnectorRadiator Coolant HoseVapor Canister Purge ValveA/C Refrigerant Temperature Sensor

Manual transmission mount bushings for other Chevrolet models

Chevrolet ChevyChevrolet CamaroChevrolet Chevy PickupChevrolet HHRChevrolet OptraChevrolet Beretta