Loading...

Chevrolet Trax Engine Oil Filter Covers

Chevrolet Trax Engine oil filter covers

Engine oil filter covers for your Chevrolet Trax start at $9.95. We stock 3 options from SKP, Dorman, and Autotecnica. The oil filter cover seals and houses the oil filter cartridge, keeping pressurized oil directed through the filter and away from leaks. A cracked or stripped cover causes oil loss, pressure drops, and engine damage if ignored.

Signs your Chevrolet Trax needs a new engine oil filter cover

  • Visible oil puddle or wet residue directly beneath the oil filter housing area
  • Oil level drops between changes with no obvious external leak elsewhere
  • Oil pressure warning light illuminates at idle or under load
  • Burning oil smell from the engine bay caused by oil dripping onto hot exhaust components
  • Cracked, chipped, or cross-threaded plastic visible on the cover itself
  • Oil filter cartridge fails to seat or seal properly even with a new filter installed

Which engine oil filter cover should you buy for your Chevrolet Trax?

The main decision is material and fitment precision. OEM-spec covers match factory thread pitch and sealing surfaces exactly, while aftermarket options vary in durability and include or exclude the drain valve and O-ring. Confirm whether your Chevrolet Trax uses a top-mount cartridge-style housing or a spin-on cap before ordering.

OEM Replacement (plastic)
Best for
Restoring factory fit and finish on a daily driver
What you get
Exact thread pitch, integrated drain valve port, and matching torque spec — direct swap with no modification
Aftermarket with O-ring kit included
Best for
Budget-conscious repairs where the original O-ring has also failed
What you get
New cover plus fresh sealing ring in one package, reducing the chance of a comeback leak
Aluminum upgraded cover
Best for
High-mileage vehicles or owners who strip plastic threads repeatedly
What you get
Greater thread durability and heat resistance, though heavier and typically requires careful torque management
Complete housing assembly
Best for
Covers where the cap, base, and drain port are all damaged or corroded
What you get
Full replacement of every sealing and structural component in one kit, minimizing leak risk at all joint points

Engine oil filter covers brands we stock for your Chevrolet Trax

SKP
1 option · from $9.95
Dorman
1 option · from $12.95
Autotecnica
1 option · from $9.95

Replacing the engine oil filter cover on a Chevrolet Trax

Easy⏱ 30–60 minutesOil filter cap wrench (correct size for your Chevrolet Trax)Torque wrenchDrain pan and shop ragsPick or O-ring removal toolClean lint-free cloth for wiping the housing seat

Drain or partially drain the engine oil, then use the correct cap wrench to remove the old cover and discard the used filter cartridge and O-ring. Clean the housing seating surface thoroughly, install the new O-ring with a light coat of fresh oil, seat the new filter cartridge, and thread the new cover on by hand before finishing with a torque wrench per the cover manufacturer's specification. Refill oil, run the engine briefly, and check for leaks before returning the Chevrolet Trax to service.

Frequently asked questions

How much does it cost to replace engine oil filter covers on a Chevrolet Trax?
Parts alone start at $9.95 for a Chevrolet Trax engine oil filter cover. Labor is typically one of the lower-cost oil system repairs because access is usually straightforward. Budget roughly 15–30 minutes of shop time unless the housing is deeply recessed or requires intake component removal.
Can I drive my Chevrolet Trax with a leaking oil filter cover?
No. Even a slow oil filter cover leak on a Chevrolet Trax can accelerate into rapid oil loss, especially under highway driving where pressure spikes. Low oil pressure causes accelerated wear on bearings and camshafts within minutes. If you see an active drip or the oil light comes on, stop and address it before driving further.
What causes an engine oil filter cover to crack or fail on a Chevrolet Trax?
The most common causes are overtightening during an oil change, which strips or splits the plastic threads, and heat cycling over time that makes the material brittle. Using an impact wrench instead of a torque wrench is a frequent culprit. Age and UV exposure to underhood heat also degrade plastic covers on older Chevrolet Trax models.
Does replacing the engine oil filter cover on a Chevrolet Trax require draining the oil?
Yes, in most cases. Removing the cover on a Chevrolet Trax exposes the oil filter cartridge cavity, which holds residual oil. Draining the engine oil first — or at minimum having rags and a drain pan ready — prevents a significant spill. Some covers include a built-in drain valve that lets oil drain before removal.
Do I need to replace the O-ring when I replace the oil filter cover on my Chevrolet Trax?
Yes, always. The O-ring is the primary seal between the cover and the housing on a Chevrolet Trax. Reusing the old, compressed O-ring is the leading cause of leaks after a new cover is installed. Many covers sold for the Chevrolet Trax include a replacement O-ring in the package — confirm before you order.
How often should the engine oil filter cover be replaced on a Chevrolet Trax?
The cover itself has no fixed replacement interval on a Chevrolet Trax — it is replaced on condition, not mileage. Inspect it at every oil change for hairline cracks, stripped threads, or a deformed sealing surface. Plastic covers on high-mileage Chevrolet Trax engines are worth proactive replacement if they show any brittleness or thread wear.

Shop engine oil filter covers by year for the Chevrolet Trax

202120202019201820172016201520142013

More parts for your Chevrolet Trax

Ignition SwitchThrottle Control Motor ConnectorEngine Timing Chain GuideEngine Oil Cooler Mounting KitRack & Pinion AssemblyRadiator Coolant HoseEngine Coolant Temperature SensorBrake Drum Set

Engine oil filter covers for other Chevrolet models

Chevrolet ImpalaChevrolet Cruze LimitedChevrolet MalibuChevrolet CruzeChevrolet CavalierChevrolet Cobalt