Loading...
Starting at low prices, AutoBuffy stocks multiple fuel injection multi-port tune-up kits from top OE-quality brands. These kits bundle fuel injectors, intake gaskets, O-rings, and related components needed to restore proper fuel atomization in multi-port systems. When injectors clog, leak, or fail, your Ford E 350 Econoline Club Wagon loses power, wastes fuel, and runs rough — making a full kit the cost-effective fix over replacing parts individually.
The most important decision is whether the kit matches your engine's exact injector flow rate, connector style, and O-ring dimensions — a mismatch causes lean or rich conditions that can damage the engine. Beyond fitment, kits vary by whether they supply remanufactured or new injectors and how complete the hardware package is. Match the kit grade to how many miles are on your fuel system and whether you want a long-term fix or a budget repair.
| Option | Best for | What you get |
|---|---|---|
| OEM-Equivalent New Kit | Vehicles still under powertrain warranty or daily drivers needing maximum reliability | New injectors matched to factory flow specs, full O-ring and seal set, and sometimes updated inlet screens |
| Remanufactured Injector Kit | High-mileage vehicles where budget matters and OEM injectors are discontinued | Professionally cleaned and flow-tested used injectors, replacement O-rings and pintle caps, typically at 30–50% savings over new |
| Performance Upgrade Kit | Modified engines with forced induction, larger cams, or higher horsepower goals | Higher flow-rate injectors (measured in cc/min or lb/hr), upgraded O-rings rated for E85 or forced-induction fuel pressures |
| Basic Seal & O-Ring Refresh Kit | Injectors that still flow correctly but are leaking externally at upper or lower O-rings | Replacement O-rings, filter baskets, pintle caps, and grommets only — no injectors included; lowest cost option |
Begin by relieving fuel system pressure using the Schrader valve or by pulling the fuel pump fuse and cranking the engine until it stalls, then disconnect the battery. Remove the intake plenum or upper manifold as needed to access the fuel rail, detach the rail with injectors attached as an assembly, and swap each injector with the new units after lubricating the O-rings with clean fuel. Reinstall in reverse order, reconnect the battery, cycle the ignition several times to repressurize the system, and check for leaks before starting the engine.