Loading...

Ford Five Hundred Parking Aid Control Module Connectors

Ford Five Hundred Parking aid control module connectors

Starting at $147.95, AutoBuffy stocks 1 parking aid control module connectors from Standard Ignition. This connector links the parking sensor control module to the vehicle's wiring harness, carrying power, ground, and sensor data signals. When it corrodes, cracks, or loses a pin, the entire parking aid system goes dark or throws false alerts — leaving you without reliable obstacle detection.

Signs your Ford Five Hundred needs a new parking aid control module connector

  • Parking aid system warning light stays on or flashes intermittently on the dash
  • All parking sensors go silent or stop beeping even when an obstacle is within range
  • Scanner shows a stored fault code pointing to the parking aid module or its power/communication circuit
  • Sensors work only sometimes — system cuts in and out depending on temperature or vibration
  • Visible corrosion, melted plastic, or a bent/pushed-back terminal at the module connector
  • Reverse gear no longer triggers the parking sensor chime even though the module and sensors test good individually

Which parking aid control module connector should you buy for your Ford Five Hundred?

The main decision is whether to buy an OEM-spec connector pigtail, a universal repair connector, or a complete connector-and-harness assembly. Fit and terminal material matter most here: a connector with the wrong pin count or inferior terminal plating will fail again quickly, especially in the rear bumper environment where moisture and road spray are constant.

OEM-equivalent pigtail connector
Best for
Exact-fit replacement with no modification needed
What you get
Correct pin count, OEM-matched terminal plating, and factory connector housing geometry
Universal repair connector with terminals
Best for
Budget fix when only one or two pins are damaged
What you get
Bare connector shell and loose terminals you crimp onto existing wires — lowest cost, more labor
Pre-wired connector pigtail (with lead wires)
Best for
Fast, splice-in repair when the connector and adjacent wiring are both damaged
What you get
Ready-to-splice pigtail that eliminates need for individual terminal work
Complete module connector + bracket assembly
Best for
When the connector, TPA lock, and mounting tab are all broken
What you get
Full assembly including secondary lock and strain-relief bracket for a like-new installation

Parking aid control module connectors brands we stock for your Ford Five Hundred

Standard Ignition
1 option · from $147.95

Replacing the parking aid control module connector on a Ford Five Hundred

Moderate⏱ 45 minutes – 1.5 hoursTerminal pick or connector release toolWire stripper and crimping toolMultimeterHeat-shrink butt connectors or solder and heat-shrink tubingElectrical contact cleaner

Locate the parking aid control module — typically mounted near the rear bumper, trunk area, or behind a kick panel — then unplug the damaged connector and use a terminal pick to release and transfer any reusable wires into the new housing, or splice a pre-wired pigtail using waterproof heat-shrink connectors. Ensure all terminal positions match the original before plugging in and applying dielectric grease to the connector face. Clear any stored fault codes with a scanner and confirm the parking aid system activates normally in reverse before closing up the trim.

Frequently asked questions

How much does it cost to replace parking aid control module connectors on a Ford Five Hundred?
The connector itself starts at $147.95 at AutoBuffy. A shop will typically charge one to two hours of labor on top of parts cost. DIYers who are comfortable with basic wiring work can often complete the splice or terminal repair in under an hour, keeping total cost close to the part price alone.
Can a bad parking aid control module connector cause false sensor alerts on a Ford Five Hundred?
Yes. An intermittent or corroded connection sends erratic voltage or signal data to the module, which can trigger false obstacle warnings or cause the system to beep continuously. The module interprets missing or fluctuating sensor signals as an active detection event, so fixing the connector often resolves ghost alerts immediately.
Is it safe to drive a Ford Five Hundred with a failed parking aid control module connector?
The vehicle is mechanically safe to drive, but you lose all proximity warning from the parking aid system. In tight parking situations, especially when reversing, you are relying entirely on mirrors and direct visibility. Repair is straightforward and low-cost, so there is little reason to leave the system non-functional.
Will replacing just the connector fix my parking aid system, or do I need a new module too?
In many cases the connector is the only failed component. Before replacing the module, clean or replace the connector, then clear any fault codes and retest. If codes return pointing specifically to an internal module fault — not a circuit or communication error — then the module itself may also need replacement.
How do I know if the connector terminals are the problem versus the wiring harness on my Ford Five Hundred?
Unplug the connector and inspect each terminal for corrosion, retraction, or spread contacts. Use a multimeter to confirm power and ground are present at the connector with the ignition on. If voltage is correct at the pins but the system still faults when plugged in, a damaged terminal or poor crimp — not the harness — is usually the cause.
Are parking aid control module connectors vehicle-specific or universal?
They are largely vehicle-specific. Pin count, connector housing shape, terminal size, and secondary lock design vary by manufacturer and model generation. Always confirm the connector matches your Ford Five Hundred by year range and part number. Universal connectors can work but require careful terminal selection and proper crimping to ensure a reliable, waterproof connection.

Shop parking aid control module connectors by year for the Ford Five Hundred

200720062005

More parts for your Ford Five Hundred

A/C Compressor Clutch Relay ConnectorHVAC Heater Hose ConnectorIgnition Lock CylinderHVAC System RelayIgnition SwitchControl Arm KitEngine Crankcase Breather HoseA/C Suction and Liquid Line Hose Assembly

Parking aid control module connectors for other Ford models

Ford E-150Ford E-450 Super DutyFord E-150 Club WagonFord E-450 Econoline Super DutyFord F-450 Super DutyFord Fiesta