Loading...
Honda Passport Wheel Bearing Kits
Honda Passport Wheel bearing kits
Starting at $56.95, AutoBuffy stocks 2 wheel bearing kits for the Honda Passport from brands including GSP and SKF. A wheel bearing kit allows your wheel to spin freely with minimal friction while keeping it precisely located on the hub. When a bearing fails, it creates noise, vibration, and — if ignored — can allow dangerous wheel play or complete wheel separation.
Signs your Honda Passport needs a new wheel bearing kit
- A growling, humming, or rumbling noise that changes pitch when you shift your weight in a turn — classic failing wheel bearing sound
- Vibration felt through the steering wheel or floorboard that increases with vehicle speed
- A grinding or clicking noise from one corner of the vehicle that worsens under load
- Noticeable looseness or wobble when you grab a jacked-up wheel at the 12 and 6 o'clock positions and rock it
- ABS warning light triggered by a worn bearing damaging the integrated wheel speed sensor ring
- Uneven or accelerated tire wear on one side caused by excessive lateral play at the hub
Which wheel bearing kit should you buy for your Honda Passport?
The most important decision is whether you need a press-in bearing kit — which requires a hydraulic press to install — or a bolt-on hub assembly kit that includes the bearing pre-packed and pre-pressed into the hub. Beyond that, consider bearing grade and whether your Honda Passport uses a serviceable tapered roller bearing (common on rear axles and older front axles) or a sealed, non-serviceable unit bearing. Always replace both sides of an axle at the same time if one is showing wear.
| Option | Best for | What you get |
|---|---|---|
| OE-Grade Sealed Hub Assembly Kit | Drivers who want a direct bolt-on replacement with no press work | Pre-packed, pre-pressed sealed bearing bonded to hub flange; includes ABS tone ring where applicable; closest match to factory spec |
| Press-In Bearing Kit (Race & Bearing Set) | Shop installs or experienced DIYers with a hydraulic press | Inner/outer bearing races plus sealed or greaseable bearing; lower part cost but requires knuckle to be pressed in a shop |
| Tapered Roller Bearing Kit | Rear axles, older front axles, and tow-duty applications requiring adjustable preload | Separate inner cone, outer cone, and races; allows preload adjustment and periodic re-greasing; more durable under heavy load |
| Heavy-Duty / Performance Upgrade Kit | High-mileage vehicles, towing/hauling, or off-road use on the Honda Passport | Higher load-rating bearings with thicker races and premium grease seals; extended service life under stress compared to standard OE replacement |
Wheel bearing kits brands we stock for your Honda Passport
Replacing a wheel bearing kit on a Honda Passport
Bolt-on hub assembly kits are the more accessible option — after removing the wheel, brake caliper, and rotor, the old hub unbolts from the knuckle and the new unit bolts directly in place. Press-in bearing kits require the steering knuckle to be removed from the vehicle and taken to a shop with a hydraulic press to remove the old races and press in the new bearing without damaging the knuckle bore. In either case, always consult the Honda Passport service manual for proper fastener torque sequences, and verify ABS sensor connector orientation before final assembly.