Silverado / Sierra 1500 Sway Bar Links (2014–2018): What They Cost, When to Replace, and How to Do It Right
Everything you need to know about sway bar links on the 2014–2018 Chevy Silverado and GMC Sierra 1500 — symptoms, costs, specs, and how to replace them.
The Short Answer
A worn sway bar link on your 2014–2018 Chevy Silverado or GMC Sierra 1500 is one of the cheapest suspension fixes you'll ever make — parts run $30–$80 a pair, the job takes under an hour with a 14mm wrench and socket, and the torque spec is a simple 17 ft-lbs.
| Item | Detail |
|---|---|
| Affected Trucks | 2014–2018 Chevy Silverado 1500, GMC Sierra 1500 |
| Common Symptom | Clunking/rattling over bumps, increased body roll |
| Parts Cost (pair) | ~$30–$80 |
| Shop Labor (front pair) | ~$80–$150 |
| Total Shop Cost Estimate | ~$110–$230 |
| DIY Tools Needed | 14mm wrench, 14mm socket, torque wrench |
| Torque Spec | 17 ft-lbs |
| OEM Reference Numbers | K700538, K700432 / K700430 |
| Warranty (MOOG) | Lifetime |
What Do Sway Bar Links Actually Do? Your sway bar — also called an anti-roll bar — runs across the front (and rear) of the truck and connects the suspension on both sides. When you take a corner, one side of the suspension compresses more than the other. The sway bar resists that difference, keeping the body flatter and the tires in better contact with the road. The sway bar links are the short connectors between the sway bar itself and the suspension control arms or struts. They're small, they flex constantly, and they're usually the first part of the sway bar assembly to wear out. When the end links go bad, the bar can't do its job — and you feel it. ---
Signs Your Silverado or Sierra Sway Bar Links Are Worn
The clunk that won't quit
The most obvious symptom is a clunking or rattling noise when you drive over bumps, dips, or uneven pavement — especially at lower speeds. It tends to be worse in cold weather because worn rubber bushings and ball joints stiffen up and have more play. If the clunk is coming from the front end and it sounds like something loose is banging around, the sway bar links are a very common culprit. ### Increased body roll
You might notice the truck leans more in corners than it used to. That "floaty" feeling isn't just annoying — it means the sway bar isn't controlling body motion the way it should. Over time, this puts extra stress on your tires and other suspension components. ### Loose or vague steering feel
When links wear out, the front end can feel less planted, almost like the steering is slightly delayed or imprecise. It's subtle at first, but it gets worse quickly once the ball studs inside the links start to develop real slop. ---
2014–2018 Silverado / Sierra: Why These Trucks Are Cross-Compatible
The 2014–2018 Chevy Silverado 1500 and GMC Sierra 1500 share the same generation platform. That means sway bar link parts are fully cross-compatible between the two nameplates — a front link that fits the Silverado fits the Sierra. This is good news for parts sourcing because inventory is plentiful and competition keeps prices reasonable. That said, you'll still want to confirm fitment by your specific year, cab configuration (regular, double, crew), and drivetrain (2WD vs. 4WD), since there can be minor variations within the generation. ---
How Long Do Sway Bar Links Last? Under normal driving conditions, expect 80,000–100,000 miles out of the factory links. Trucks that tow regularly, carry heavy payloads, or see rough roads will see wear happen faster — sometimes as early as 50,000–60,000 miles. The Silverado and Sierra are work trucks, and a lot of them live hard lives. If you're past 75k and hear any of the symptoms above, the links are worth checking before you start chasing more expensive problems. ---
DIY Replacement: Tools, Specs, and Process
This is genuinely one of the easiest suspension jobs you can do. Here's what you'll need and what to expect. ### Tools required
- 14mm wrench
- 14mm socket and ratchet
- Torque wrench
- Jack stands (if lifting the truck)
Key specs
- Torque spec: 17 ft-lbs on the sway bar link nut
- OEM reference numbers: K700538 (one side), K700432 or K700430 (other side)
Basic process
- Safely lift and support the truck (or just access from below if clearance allows). 2. Use the 14mm wrench and socket to break loose the upper and lower link nuts — hold the stud with the wrench to prevent spinning. 3. Remove the old link. If the ball joint spins in the stud, the link is already past its service life. 4. Install the new link, hand-tighten the nuts, then torque to 17 ft-lbs. 5. Lower the truck and take it around the block — the clunk should be gone immediately. The whole job on both sides typically takes 30–45 minutes for someone who's done it once before. Even a first-timer should finish in under an hour. ---
Should You Buy Links Alone or a Full Suspension Kit? If your truck is under 60,000 miles and you've confirmed the links are the only worn component, buying a pair of links on their own makes perfect sense. But if you're over 80,000 miles and you're already under the truck with it in the air, take five minutes to check the control arm bushings and ball joints while you're there. MOOG offers front sway bar links bundled with control arms in multi-piece kits. These suspension kits make sense when more than one component is showing wear — buying them together is more economical than purchasing separately, and you avoid pulling the front end apart again in a few months for the next worn part. Use the part finder below to see which kit configuration fits your exact truck and get current pricing. ---
Which Brand Should You Buy? The inventory available here is MOOG, which is a DRiV brand — DRiV itself is a Tenneco company, currently owned by Apollo Global Management. MOOG has been a go-to name in suspension for decades, and their sway bar end links carry a **lifetime warranty** — that's not a limited warranty, it's a lifetime replacement guarantee. For a part that costs what sway bar links cost, that warranty is genuinely meaningful and removes any risk from the purchase. My honest take: for a truck this age, I'd put MOOG at the top of the list specifically because of that lifetime warranty coverage. If you're buying once and don't want to think about it again, that matters more than saving a few dollars on a bare-bones link with no coverage behind it. ---
Don't Forget the Rear Links
Most owners — and a lot of shops — focus on the front sway bar links because that's where the noise is loudest. But the rear links wear out too, just more quietly. If your truck has high miles, check the rear links at the same time. A quick visual inspection (look for cracked bushings, loose ball joints, or obvious play in the link) takes two minutes and can save you a return trip. ---
Why buy from AutoBuffy
- Fitment check: add your vehicle and we confirm the part fits before you buy. If it doesn't fit because of our listing, you get a free return and a full refund, including original shipping.
- 24-month limited warranty on new parts bought on autobuffy.com.
- Real reviews: rated 4.9 by 19,069 verified customers.
- 30-day returns on unused parts in the original packaging.
- Free shipping on orders $50+. Orders placed before 12:00 PM ET (Mon-Fri) ship the same business day.
- Questions about an order? Call 888-477-2530 or email help@autobuffy.com.
Find the right sway bar link for your Silverado or Sierra
Guaranteed fit, ships free
FAQ / People Also Ask
The most common sign is a clunking or rattling noise over bumps, especially at low speeds. You may also notice increased body roll when cornering, a loose or wandering steering feel, or uneven tire wear. In some cases the noise gets worse in cold weather as worn bushings stiffen up.
Keep Reading

Honda Element Rear Upper Control Arm (Camber Arm): What It Does, When to Replace It, and How to Choose
7
Nissan Frontier Upper Control Arms (2005–2021): What You Need to Know Before You Buy
7


Comments
Loading comments...
Comments are moderated by the AutoBuffy team.