Loading...
Starting at $15.95, AutoBuffy carries 2 multi-purpose relays from Denso for the Toyota Grand Highlander. A multi-purpose relay is a small electromechanical switch that uses low-current signals to control high-current circuits — powering components like fuel pumps, cooling fans, and accessories. When it fails, those circuits go dead without warning, leaving you stranded or with a vehicle that won't start.
Multi-purpose relays are rated by coil voltage (almost always 12V for passenger vehicles), terminal count, and current-handling capacity — matching those specs to your Toyota Grand Highlander's original relay is the most important buying decision. Beyond the spec match, you'll choose between OE-equivalent, heavy-duty, and universal-fit options depending on how the relay is used and how often that circuit is stressed.
| Option | Best for | What you get |
|---|---|---|
| OE-Equivalent (Direct-Fit) | Daily drivers needing a straightforward, plug-and-play replacement | Same terminal layout, coil resistance, and current rating as the factory relay — no wiring modification required |
| Heavy-Duty / High-Amp | High-draw circuits like cooling fans, aftermarket lighting, or winches | Upgraded contact rating (typically 40–80A) that resists heat and arcing better than a standard relay |
| ISO Mini Relay (5-pin) | Positions requiring a compact, widely available form factor | Standard ISO footprint compatible with most relay sockets; easy to source and swap roadside |
| Universal Relay with Harness | Custom builds, modified vehicles, or corroded sockets needing a full repair | Pre-wired pigtail lets you splice into the circuit without a matching socket, bypassing corrosion or damage |
Locate the correct relay using the fuse box diagram on the cover or in your owner's manual, then pull the old relay straight out and push the new one firmly into the same socket. Before installing the new relay, inspect the socket terminals for corrosion and apply a small amount of dielectric grease to protect against moisture. Reconnect any power if it was disconnected, then verify the controlled circuit operates correctly before closing the fuse box.