Loading...

Toyota Venza Engine Crankcase Breather Hoses

Toyota Venza Engine crankcase breather hoses

Starting at $27.95, AutoBuffy stocks 2 engine crankcase breather hoses from Standard Ignition and Gates. This hose vents blow-by gases from the crankcase back into the intake to be burned, keeping pressure balanced inside the engine. When it cracks or clogs, oil leaks, rough idle, and failed emissions tests follow quickly.

Signs your Toyota Venza needs a new crankcase breather hose

  • Rough or unstable idle caused by an unmetered air leak entering the intake through a cracked hose
  • Oil residue or a visible oily film around the hose connections, valve cover, or air intake tube
  • Check Engine light with codes related to the PCV system, lean fuel trim, or evaporative emissions
  • Increased oil consumption with no obvious external leak — crankcase pressure forces oil past seals
  • White or blue smoke from the exhaust, especially on startup, as trapped blow-by oil burns off
  • Failed emissions or smog inspection due to elevated hydrocarbons from a malfunctioning crankcase ventilation path

Which crankcase breather hose should you buy for your Toyota Venza?

The main decision is whether to buy an OE-equivalent replacement hose or an upgrade material. You also need to confirm whether your Toyota Venza uses a single breather hose or a multi-piece hose-and-fitting assembly, since some applications require the full kit to seal properly. Matching the correct routing position — air box side versus valve cover side — matters just as much as material.

OE-Equivalent Rubber Hose
Best for
Daily drivers needing a straightforward, cost-effective fix
What you get
Molded shape matches factory routing; nitrile or EPDM rubber resists oil and heat to OE specification
Reinforced Silicone Hose
Best for
Higher-mileage engines or vehicles in extreme heat climates
What you get
Silicone resists cracking longer than standard rubber and tolerates wider temperature swings without hardening
Complete Breather Hose Kit
Best for
Vehicles where the hose, grommet, and fittings are all worn or sold as an assembly
What you get
Includes all connecting pieces so you replace the entire ventilation path in one job, eliminating multiple failure points
PCV-Integrated Breather Hose
Best for
Applications where the breather hose and PCV valve are molded as a single unit
What you get
One-piece design eliminates a common junction leak point; sourced direct from OE suppliers or quality aftermarket brands

Engine crankcase breather hoses brands we stock for your Toyota Venza

Standard Ignition
1 option · from $28.95
Gates
1 option · from $27.95

Replacing the crankcase breather hose on a Toyota Venza

Easy30–60 minutesFlathead screwdriver or hose-clamp pliersPick tool or trim removal tool (for stuck grommets)Shop rags and glovesFlashlight or work light

With the engine cool, trace the breather hose from the valve cover or oil separator to its connection at the air intake or air box, then loosen any clamps and pull both ends free. Clean any oil residue from the connection points before pressing the new hose into place and securing the clamps snugly. On vehicles with a one-piece PCV-integrated assembly, the PCV valve should be replaced at the same time since it typically cannot be reused once removed.

Frequently asked questions

How much does it cost to replace crankcase breather hoses on a Toyota Venza?
Parts start at $27.95 on AutoBuffy. A shop will typically add one to two hours of labor on top of the part cost, though many owners complete this repair themselves in under an hour. Total out-of-pocket cost varies by whether a single hose or a full kit is needed for your Toyota Venza.
Can I drive my Toyota Venza with a cracked crankcase breather hose?
Short trips are possible, but driving with a failed breather hose is not advisable. Crankcase pressure builds up without a proper vent path, forcing oil past gaskets and seals. Unmetered air entering the intake also skews the fuel mixture, which can cause misfires and accelerate engine wear over time.
Will a bad crankcase breather hose cause my Toyota Venza to fail an emissions test?
Yes. A cracked or clogged breather hose disrupts the closed crankcase ventilation system, allowing unburned hydrocarbons to escape rather than recirculate into the intake. This raises tailpipe emissions and can trigger a Check Engine light, both of which are grounds for failing a smog or OBD-II emissions inspection on a Toyota Venza.
How long does a crankcase breather hose last on a Toyota Venza?
Most OE rubber breather hoses last somewhere between 60,000 and 100,000 miles, but heat cycles, oil exposure, and climate accelerate deterioration. Hoses on turbocharged or high-output engines tend to degrade faster. Inspecting the hose for brittleness, cracks, or soft spots during every major service interval is a good habit.
Is a crankcase breather hose the same as a PCV hose on a Toyota Venza?
They are related but not identical. The PCV hose connects the PCV valve to the intake manifold under vacuum. The breather hose vents the opposite side of the crankcase, often to the air intake or air box, and operates without vacuum. Both are part of the closed crankcase ventilation system and should be inspected together.
How do I know which crankcase breather hose fits my Toyota Venza?
Use AutoBuffy's year-make-model lookup to confirm fitment before ordering. Breather hose routing varies significantly across engine families — even within the same Venza — depending on engine displacement, trim level, and whether the vehicle is turbocharged. Matching the correct part number ensures the molded shape and connection diameter fit without modification.

Shop engine crankcase breather hoses by year for the Toyota Venza

More parts for your Toyota Venza

Engine crankcase breather hoses for other Toyota models